The impact of micron level silicon nitride (Si3N4) filler on the multipass condition two‐body abrasive wear behavior of carbon fabric‐reinforced epoxy (C‐E) composites was examined in this study. Using a Pin‐on‐Disc tribometer, the tribological behavior of the produced composites was evaluated at 5 N and 10 N as well as at different abrasive distances of 25, 50, 75, and 100 m. Silicon carbide abrasive papers were used for the experiments. It was found that when the abrading distance and load were increased, the wear volume loss of the composite samples also increased. Notably, the hybrid composite H3 (containing 6 wt% Si3N4) exhibited the lowest specific wear rate (SWR), ranging from 0.2064 × 10−10 to 0.0074 × 10−10 m3/N m. The addition of Si3N4 improved the composite abrasion resistance considerably; when the content was increased from 2 to 4 wt%, the SWR decreased by 67.3%. A more significant decrease of 96.4% in SWR was attained by increasing to 6 wt% Si3N4 loading, indicating superior wear resistance. In comparison to the unfilled C‐E composite, the C‐E with 6 wt% Si3N4 filled composite demonstrated a 33.1% reduction in wear volume loss at 5 N. The results demonstrate that Si3N4 incorporation significantly enhances the abrasion resistance of C‐E composites by reducing both fiber and matrix wear through the formation of a protective transfer film that prevents large‐scale fragmentation. Scanning electron microscopy analysis revealed the underlying wear mechanisms, while the hybrid composites exhibited a strong correlation between wear volume loss and material hardness. These findings indicate promising applications in automotive brake systems, power plant components, and industrial bearings where superior wear resistance is critical.
However, the natural fibre reinforced polymer composites are prone to absorb fluids and swell when they are in contact with working fluids such as water, sea water, alcohol, acids etc. Absorption of such working fluids leads to change in characteristics of composite materials. Hence, the present work aims to analyse the swelling and weight gain behaviour of pine apple leaf fiber (PALF) reinforced composite material in different working fluids. The specimen are prepared and tested according to ASTM standard D5229 under different fluids like normal water, sea water, dilute HCl acidic solution, bases, hydrocarbons, petrol and diesel. The minimum change in relative weight and thickness of 2.3% and 1.8% respectively is obtained for sea water when compared to other fluids. The maximum adsorption of moisture takes place for NH4OH of relative weight fraction of 29.5% and relative thickness of 14.95%.
1 July 2019 in Journal of Physics: Conference Series
These days, composite materials successfully substitute the traditional materials due to its various significant applications. This paper examines the influence of fiber orientation and fiber length on electrical properties of PALF reinforced Bisphenol-A composite and explores the potential of using PALF as reinforcing material for electrical applications such as terminals, connectors, motor body cover, industrial and household plugs and circuit boards. The resistance and inductance of resin material is increased by 24.19% and 24.13% respectively after reinforcement of PALF in different orientations and its value increased by 37.93% and 37.81% respectively after reinforcement of PALF in different lengths. Similarly, Capacitance and Dielectric constant of resin material decreased by 19.44% and 19.39% respectively after reinforcement of PALF in different orientations and its value decreased by 27.67% and 27.50% respectively after reinforcement of PALF in different lengths. It can be inferred from this study that the fiber orientations and fiber lengths greatly effects the electrical properties of PALF composite.