Gbemeho Gilou Agbaglah

Dr. Gbemeho Gilou Agbaglah

orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 January 2021 in Journal of Fluid Mechanics
Verified
Journal Article
Open access
PDF file
GAGbemeho Gilou Agbaglah
Gbemeho Gilou Agbaglah
The dynamics of the merging of two distinct holes (hole–hole) and a single hole with a straight rim (hole–rim) are investigated using three-dimensional numerical simulations. Thin liquid sheets with thicknesses ranging from are considered using air/water conditions. Preliminary simulations of a single hole expansion and the retraction of a bounded liquid sheet edge have shown good agreements with the well-known Taylor–Culick end rim regime. For the hole–hole and the hole–rim cases, our computations reveal that the liquid bridge, formed after the merging, is subjected to three different motions: the extension of the bridge, the mid-plane contraction and vertical/horizontal oscillations of its diameter, with an exponentially decaying amplitude. The mid-plane diameter of the liquid bridge is shown to decrease linearly with time for the hole–rim case while a faster quadratic decrease is observed for the hole–hole case. The small ratio of the extension rate to the capillary contraction rate indicates a slow extension limit of the bridge. However, the liquid bridge does not contract and pinch off on a single point, as predicted in the literature, and its central part forms a cylindrical ligament. Thus, this cylindrical part pinches off at its ends and forms a receding ligament with bulbous ends which can either detach by the end-pinching mechanism or remain attached, recoil and merge into a single large drop. The size of the formed drop, in the case where the ligament does not break, is later expressed as a power-law function of the initial liquid sheet thickness.

7 November 2017 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
GAGbemeho Gilou Agbaglah
Gbemeho Gilou Agbaglah
CMC. Mavriplis
C. Mavriplis
A high-order spectral element method is used to perform direct numerical simulations of flow past a square cylinder at the transition from the two-dimensional von Kármán vortex street in the wake of the cylinder to three-dimensionality. A Reynolds number range between 100 and 300 has been considered and good agreement with previous numerical and experimental results is obtained. At transition, the spanwise perturbation observed in the cylinder wake occurs before the onset of the streamwise vortex separation, while the former mechanism is commonly shown, in the literature, to originate from the latter by an instability of the cores or interactions of shed vortices in the vicinity of the cylinder. It is shown that the first three-dimensional unstable mode, the mode $A$ , originates from an axial stretching of the upstream perturbed vorticity, existing on the braids, due to the strain field created by the spanwise vortices which evolve under a shear instability of the wake when viscous effects are small. On the other hand, the mode $B$ is observed to arise only after spanwise vortices are shed downstream of the cylinder.

10 May 2019 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
GAGbemeho Gilou Agbaglah
Gbemeho Gilou Agbaglah
CMCatherine Mavriplis
Catherine Mavriplis
The flow in the near wake of a square cylinder at Reynolds numbers of 205 and 225, corresponding to three-dimensional wake instability modes $A$ and $B$ , respectively, and that of the square’s circumscribed circular cylinder are examined by using three-dimensional Navier–Stokes numerical simulations. At small times, prior to the streamwise vortex shedding, a self-similar velocity is observed in the wake and no significant difference is observed in the dynamics of the flows past the square and the circular cylinders. The exponential growth of the three-dimensional instability reaches a saturation regime during this early time for the considered Reynolds numbers. Vortical structures in the wake at long times and shedding frequencies are very close for the square and the circular cylinders. The flow separation on the forward top and bottom corners of the square cylinder have the effect of increasing its effective width, making it comparable with the diameter of the circumscribed circular cylinder. Thus, Floquet multipliers and modes of the associated three-dimensional instabilities are shown to be very close for the two cylinders when using the circumscribed circular cylinder as the basis for a characteristic length scale. Most importantly, the wavenumber with the maximum growth rate, for modes $A$ and $B$ , is approximately identical for the two cylinders.

1 March 2021 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
MVM. Vadsola
M. Vadsola
GAGbemeho Gilou Agbaglah
Gbemeho Gilou Agbaglah
CMCatherine Mavriplis
Catherine Mavriplis
A three-dimensional computational fluid dynamics analysis of low Reynolds number [ O ( 10 4 ) ] flow over a 30P30N three-element high lift wing is carried out using a high-order spectral element method. In this article, we study the flow in the slat cove region and the slat wake/shear layer interaction. Vortical structures, identified in the computations, are very similar to those visualized in recent experiments. For Reynolds numbers below a critical interval (found in recent experiments), Görtler vortices are observed in the slat wake, while for Reynolds numbers above the critical interval, a roll-up is observed in the slat cove and both streamwise and spanwise vortices form in the slat wake. Prior to the formation of Görtler and roll-up vortices, three-dimensional tongue- or rib-like vortex shapes, similar to those found in the wake of bluff bodies, are observed in the slat cove and promote transition to three-dimensional flow. Above the critical interval, streaks and spanwise vortices are observed to dominate the slat wake and lead to the formation of hairpin vortices which contribute to the transition to turbulence. Integral flow parameters such as lift, drag, and pressure coefficients are analyzed in the range of Reynolds numbers studied.

1 June 2021 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
GAGbemeho Gilou Agbaglah
Gbemeho Gilou Agbaglah
This study reports aerodynamics effects of a fully developed double-shear layer gas flow in the perforation and disintegration of a thin liquid sheet using three-dimensional numerical simulations. A double-shear layer gas flow, where a thin quiescent gas layer is sandwiched between the two fast moving gas layers, is first simulated up to a statistically steady state. The downstream dynamics of the gas shear layers shows vortex shedding and three-dimensional rib-like vortical structures, similar to the wake of a bluff body. This gas flow is then used as the initial condition for a liquid-gas simulation, where the liquid phase is sandwiched by the top and bottom fast gas streams. A thin liquid sheet with a thickness of 25 μm is considered using air/water conditions. The liquid sheet oscillates and small holes, preceded by craters surrounded by ripples, are formed. The thinning of the liquid sheet, spanwise corrugations, and vortex separations within the liquid-gas boundary layer are shown to govern the dynamics of the liquid sheet. A localized pressure jump is also observed inside the liquid sheet and precedes the rupture of the liquid sheet by pushing the liquid away in the span direction. The holes formed subsequently grow in size, collide and merge with each other, and break the liquid sheet into multiple droplets.

1 March 2019 in Journal of Computational Physics: X
Verified
Journal Article
Open access
NCN. Chalmers
N. Chalmers
GAGbemeho Gilou Agbaglah
Gbemeho Gilou Agbaglah
MCM. Chrust
M. Chrust
CMCatherine Mavriplis
Catherine Mavriplis