Egor Gordeev

Mr. Egor Gordeev

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 May 2023 in Membranes
Verified
Journal Article
Open access
PDF file
EGEgor Gordeev
Egor Gordeev
SBSemyon A. Belyakov
Semyon A. Belyakov
EAEkaterina P. Antonova
Ekaterina P. Antonova
Denis OsinkinDenis Osinkin
Denis Osinkin
Membranes based on complex solid oxides with oxygen-ionic conductivity are widely used in high-temperature electrochemical devices such as fuel cells, electrolyzers, sensors, gas purifiers, etc. The performance of these devices depends on the oxygen-ionic conductivity value of the membrane. Highly conductive complex oxides with the overall composition of (La,Sr)(Ga,Mg)O3 have regained the attention of researchers in recent years due to the progress in the development of electrochemical devices with symmetrical electrodes. In this research, we studied how the introduction of iron cations into the gallium sublattice in (La,Sr)(Ga,Mg)O3 affects the fundamental properties of the oxides and the electrochemical performance of cells based on (La,Sr)(Ga,Fe,Mg)O3. It was found that the introduction of iron leads to an increase in the electrical conductivity and thermal expansion in an oxidizing atmosphere, while no such behavior was observed in a wet hydrogen atmosphere. The introduction of iron into a (La,Sr)(Ga,Mg)O3 electrolyte leads to an increase in the electrochemical activity of Sr2Fe1.5Mo0.5O6−δ electrodes in contact with the electrolyte. Fuel cell studies have shown that, in the case of a 550 µm-thick Fe-doped (La,Sr)(Ga,Mg)O3 supporting electrolyte (Fe content 10 mol.%) and symmetrical Sr2Fe1.5Mo0.5O6−δ electrodes, the cell exhibits a power density of more than 600 mW/cm2 at 800 °C.

7 November 2023 in Electrochemical Materials and Technologies
Verified
Journal Article
Open access
PDF file
EGEgor Gordeev
Egor Gordeev
NPNatalia Porotnikova
Natalia Porotnikova
This review focuses on Sr/Mg doped lanthanum gallate and its use as a dense electrolyte for medium-temperature solid oxide electrochemical devices. Methods for synthesizing the material are discussed, including techniques that lower the temperature required to attain a single-phase crystalline structure. The effects of secondary phases and grain size on conductivity of ceramics are also investigated. Moreover, the techniques used for compacting electrolyte powder and reducing energy expenses, as well as the impacts of sintering aids on ceramic properties, are analyzed. The potential advantages and disadvantages of the proposed alterations to generate an electrolyte from doped lanthanum gallate are evaluated.

4 March 2023 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
Denis OsinkinDenis Osinkin
Denis Osinkin
DZDmitriy Zakharov
Dmitriy Zakharov
AKA.V. Khodimchuk
A.V. Khodimchuk
EAEkaterina P. Antonova
Ekaterina P. Antonova
NBN.M. Bogdanovich
N.M. Bogdanovich
NPN.M. Porotnikova
N.M. Porotnikova

16 July 2025 in Journal of Power Sources
Verified
Journal Article
Closed access
EGEgor Gordeev
Egor Gordeev
AKAnna V. Khodimchuk
Anna V. Khodimchuk
SBS.A. Belyakov
S.A. Belyakov
EAEkaterina P. Antonova
Ekaterina P. Antonova
Denis OsinkinDenis Osinkin
Denis Osinkin

3 October 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
EGEgor Gordeev
Egor Gordeev
EAEkaterina P. Antonova
Ekaterina P. Antonova
Denis OsinkinDenis Osinkin
Denis Osinkin
R&D in the area of high-temperature symmetrical electrochemical devices is needed to meet the challenges of hydrogen energy. In the present study, the effect of Fe2O3 and CuO sintering aids on the electrochemical properties of the highly conductive solid electrolyte La0.8Sr0.2Ga0.8Mg0.2O3−δ and La0.6Sr0.4FeO3−δ electrodes for symmetrical solid oxide fuel cells was investigated. It is shown that the use of sintering aids leads to an improvement in grain boundary conductivity and allows us to reduce the sintering temperature to obtain a dense electrolyte with the same level of conductivity. It is shown for the first time that the nature of the sintering aids and the sintering temperature affect the La0.6Sr0.4FeO3−δ electrode activity differently depending on the gas environment (air or hydrogen). On the basis of the analysis of the impedance spectra by the distribution of relaxation times, assumptions were made about the nature of the rate-determining steps of hydrogen oxidation and oxygen reduction. It is shown that the nature of the rate-determining steps can change depending on the electrode sintering temperature. It was found that among the studied electrodes, La0.6Sr0.4FeO3−δ with 3 wt.% Fe2O3 sintered at 1050 °C is optimal in terms of activity in oxidizing and reducing atmospheres.