The non-equilibrium Green’s function formalism method is used to simulate electronic transport in a quantum cascade laser. Calculations are performed in a real-space basis defined by the grid points. Implementation of a non-uniform mesh greatly improves the effectiveness of the method, allowing for realistic mapping of the device structure while keeping the numerical load achievable for personal computers. The results of simulations obtained employing a non-uniform mesh are shown to fit the experimental data much better than those using constant grid sampling.
30 December 2016 in Optical and Quantum Electronics
Non-equilibrium Green’s function method is used to analyze electronic transport in a mid-infrared quantum cascade laser on microscopic level. Basing on the excellent agreement found between calculated and experimental data, the conclusions are derived that the carrier distribution in the lower laser subband is non-thermal, and the carriers are extracted from active region both in cold and hot state. An estimate \(\tau _{3}=0.66\) ps for upper lifetime at 77 K was found which considerably differs from the value 1.4 ps evaluated from the form factors.
Non-equilibrium Green’s function (NEGF) formalism is used to optimize the gain region of a quantum cascade laser (QCL) tailored to emit radiation at ∼5 µm wavelength, originally designed by Evans et al. [ Appl. Phys. Lett., 88, 051105(2006)10.1063/1.2171476 ]. The optimization strategy uses electron-photon selfenergies to find characteristics of devices under the "operating conditions," i.e., interacting with the laser field. These conditions can be quite different from the one when the device is in no-lasing state and the unsaturated gain is being optimized. The saturation caused by the optical field can push the structure from strong to weak coupling conditions, what changes laser parameters in a non-linear manner. Moreover, the NEGF method does not require any phenomenological parameters (such as, e.g., the phase relaxation times), so the quantities dependent on these parameters are determined solely on physical grounds. The use of the above procedure for the structure under investigation shows that the increase of the quantum efficiency by 24% and the output power by 83% in comparison to the original design can be achieved when the widths of injection and extraction barriers are changed to their optimal values.
Numerical research into the QCL tunability aspects in respect to being applied in chemical substance detection systems is covered in this paper. The QCL tuning opportunities by varying power supply conditions and geometric dimensions of the active area have been considered. Two models for superlattice finite (FSML) and infinite (RSM) size were assumed for simulations. The results obtained have been correlated with the absorption map for selected chemical substances in order to identify the potential detection possibilities.
24 September 2019 in Optical and Quantum Electronics
Nonequilibrium Green’s function method is used to calculate electronic and optical characteristics of various quantum cascade structures emitting light at ~ 5.2 μm wavelength. Basing on these simulations, the choice of optimal design can be done.
Tuning the wavelength of emitted radiation is a tremendous feature of quantum cascade lasers which enables their use in various applications. Usually, this tuning is executed by the change of the bias current or the temperature. In this paper, it is demonstrated, both experimentally and theoretically, that yet another possibility of tuning laser wavelength offers the change of doping density. For the experimental demonstration, a set of GaAs/AlGaAs devices emitting in the range 9.3–9.7 µ\({\rm {m}}\) was MBE grown and processed. For the theoretical analysis, the simulations that employ nonequilibrium Green’s function formalism, applied to the single-band effective mass Hamiltonian, are used. The analysis shows that the physical mechanism responsible for wavelength-doping correlation is a linear Stark effect. The range of tuning is limited on both low and high doping side. Both these limits are established and discussed.