Aqueous supercapacitors had recently received widespread attention due to their eco-safety, cost-efficiency, environmental friendliness, and ease of handling. However, being limited by the voltage of decomposition of water, the operating voltage of aqueous supercapacitors is usually 2 V, which mostly impedes the improvement of energy density (E = 0.5 CV2). In the present study, we illustrate that a VN nanowires@carbon cloth (VN-NWs@CC) electrode possesses a wide potential stability window of −1.4–0.7 V in a high concentration “water in salt” aqueous electrolyte, which can be attributed to the redox reactions occurring at low potentials, delaying the process of hydrogen evolution reaction (HER). Furthermore, the asymmetric supercapacitor, based on a VN-NWs@CC negative electrode and MnO2 nanosheet positive electrode, can obtain a high operating voltage of 3 V. Moreover, the 3 V MnO2@CC//VN-NWs@CC asymmetric supercapacitor exhibits a large energy density of up to 61.5 W h kg−1 with excellent cycling stability, outperforming previously reported VN-based supercapacitors. This work provides the possible chance for providing high operating voltage for aqueous supercapacitors, comparable even with those of batteries.
Covalent organic frameworks (COFs) are attractive organic polymers that can serve as promising photocatalysts for water reduction. Herein, two novel arylboron functional COFs, TAB-TFB-COF and TAB-TFP-COF, were synthesized and their photocatalytic hydrogen evolution ability was evaluated. Under visible light irradiation (λ > 420 nm), the hydrogen evolution rate of TAB-TFP-COF is 666.4 μmol g−1 h−1 at the stationary point (0.5 g L−1), reaching 1140 μmol g−1 h−1 after long cycle stabilization, which is 76 and 1.4 times higher than that of TAB-TFB-COF (8.8 μmol g−1 h−1) and TAB-TFP-CMP (489.6 μmol g−1 h−1), respectively. It is demonstrated that the construction of β-ketoenamine improves the separation and transfer ability of light-induced charge carriers. Specifically, F−-loading experiments and density functional theory (DFT) calculations suggested that the introduction of arylboron units promoted intramolecular charge transfer which was conducive to photocatalytic reactions. Overall, the good photocatalytic performance of TAB-TFP-COF is due to the synergistic catalytic effect of arylboron and β-ketoenamine dual acceptors. The arylboron functionalization may open up new avenues for the development of COFs in photocatalytic materials, making them promising for a variety of applications as advanced solar energy conversion platforms.
It is reported that Li ions can contribute a lot to the capacitance of aqueous Li-ion capacitors (LICs), which might be due to the intercalation/de-intercalation processes of Li+ ions that also occur at the anodes. However the energy storage mechanism in the aqueous LIC system still requires further proof. In this work, a type of aqueous fiber-shaped LIC has been designed and developed using hydrogenated Li4Ti5O12 (H-LTO) anodes, active carbon (AC) cathodes, and LiCl/PVA gel electrolytes with a double-helical structure. The obtained single LTO wire electrode exhibits a high specific capacitance in volume (34.1 F cm−3) and superior cycling stabilities (∼100% over 100 000 cycles), both of which are due to the formed amorphous layers at the surface of the electrodes. Moreover, it is found via sweep voltammetry analysis that most of the energy stored in an aqueous fiber-shaped capacitor electrode is attributed to the Li ions’ intercalation, whose content exceeds 85% at a low scan rate and gradually decreases with increasing scan rate; while the energy stored by the double electric layers remains almost unchanged with different scan rates. Furthermore, the well-matched wearable fiber-shaped LICs show high capacitive behaviors (18.44 μW h cm−2) and superior static/dynamic cycling stabilities. This research would provide some insight into the charge storage mechanism in electrodes in the aqueous system, and give more suggestions to develop high-energy-density fiber-shaped energy storage devices.