A rapid downstream weakening of the processes that drive the intensity of transverse mixing at the confluence of large rivers has been identified in the literature and attributed to the progressive reduction in channel scale secondary circulation and shear-driven mixing with distance downstream from the junction. These processes are investigated in this paper using a three-dimensional computation of the Reynolds averaged Navier Stokes equations combined with a Reynolds stress turbulence model for the confluence of the Kama and Vishera rivers in the Russian Urals. Simulations were carried out for three different configurations: an idealized planform with a rectangular cross-section (R), the natural planform with a rectangular cross-section (P), and the natural planform with the measured bathymetry (N), each one for three different discharge ratios. Results show that in the idealized configuration (R), the initial vortices that form due to channel-scale pressure gradients decline rapidly with distance downstream. Mixing is slow and incomplete at more than 10 multiples of channel width downstream from the junction corner. However, when the natural planform and bathymetry are introduced (N), rates of mixing increase dramatically at the junction corner and are maintained with distance downstream. Comparison with the P case suggests that it is the bathymetry that drives the most rapid mixing and notably when the discharge ratio is such that a single channel-scale vortex develops aided by curvature in the post junction channel. This effect is strongest when the discharge of the tributary that has the same direction of curvature as the post junction channel is greatest. A comprehensive set of field data are required to test this conclusion. If it holds, theoretical models of mixing processes in rivers will need to take into account the effects of bathymetry upon the interaction between river discharge ratio, secondary circulation development, and mixing rates.
As a rule, large modern industrial complexes are significant water users. This raises the problem of providing them with reliable and sustainable water supply systems. To solve this problem, relatively small, special reservoirs for technical water supply are often created. When creating them, it is a priori assumed that their water masses will be comparatively homogeneous over the aquatorium and throughout the depths, and so, therefore, that their flushing can be successfully used to prevent a possible accumulation of pollutants. The experience of operating such reservoirs in the Verkhnekamsky potassium and magnesium salt development zone in Ural, Russia, has shown that, due to intense diffuse pollution, the reservoirs are characterized by significant vertical non-uniformity, fundamentally altering the hydrodynamics of these water bodies. Based on a series of research, including field observations and computational experiments, the present paper reveals that the vertical non-uniformity of water masses plays a key role in ensuring the sustainability of technical water supply.
1 December 2019 in Journal of Applied Mechanics and Technical Physics
At present, a significant weakening of the intensity of transverse mixing at the confluence of large rivers, which is observed in a number of cases, is widely discussed. Since the observed features...
The industrial production of chemicals, including the manufacture of mineral fertilizers, is often associated with the need for the disposal of highly mineralized brines through their discharge into surface water bodies or an underground water-bearing layer. When dealing with surface water bodies, the problem of the hyporheic zone effect could substantially influence the process and, thus, must be examined. We consider a two-layer system (liquid–porous medium) for a detailed assessment of the importance of considering the hyporheic zone during the modeling of brine discharge. A three-dimensional numerical simulation of brine transport is performed for parameters close to the characteristics of the media and flows typical for natural water bodies. The dynamics of a saturated brine in a two-layer system are studied for the period of brine discharging and after the cessation of the disposal, and the accumulation of salts in the bottom porous layer is assessed. Calculations show that a significant amount of impurities is observed not only near the water body bottom but also throughout the entire thickness of the porous layer. Moreover, the obtained data reveal that the effect of vertical stratification dramatically influences the brine discharge process and leads to propagation of the brine into the porous medium with a velocity that is three orders of magnitude higher than the filtration rate in the horizontal direction. As a result, the heterogeneity in the depth distribution of the impurity concentration is significant. In particular, the maximum concentration of salt in the hyporheic zone exceeds those near the river surface by hundreds of times. Impurities accumulated in the water-bearing layer of the river bottom are nonhazardous at low- and medium-flow rates. However, with an increase in the river flow intensity—for example, during the flood period or caused by operating regime of a hydroelectric power plant—the accumulated contamination may become an intensive source of pollution, which significantly limits the water use regime.
1
1 January 2015 in Computational Continuum Mechanics
The hydrological regimes of surface water bodies, as a rule, are unsteady. However, accounting for the non-stationarity substantially complicates the hydrodynamic calculations. Because of this, the scenario approach is traditionally used in the calculations. Characteristic scenarios are set with constant hydrological characteristics throughout the time covered in the calculations. This approach is fully justified if the characteristic time of the change in water flow rate is much longer than the calculation time. However, nowadays, tasks are becoming more and more urgent when accounting for flow variability during calculation period becomes crucial. First of all, such a problem arises when assessing the effect of non-stationary water discharge through hydroelectric power plant dams on the hydrodynamic regime of both the upper and lower pools of the reservoir. In the present paper, the effect of the intraday variability of the Kamskaya Hydroelectric Power Plant (Kamskaya HEPP) operation on the peculiarities of the hydrodynamic regimes of the near-dam part of the upper pool of the Kama reservoir is described. The importance of the problem is determined by the location of the main drinking water intake of Perm city and one of the largest thermal power plants (TPP) in Europe, Permskaya TPP, in this part of the reservoir. This TPP uses a direct-flow cooling system from the Kama reservoir, which is very sensitive to the peculiarities of the hydrodynamic regime of the reservoir. The computational experiments based on the combined hydrodynamic models in 2D/3D formulations have shown that the intraday oscillations of the discharge flow rate through the dam of the HEPP have a very significant effect on the hydrodynamic regime of the reservoir in the vicinity of the Permskaya TPP; therefore, these effects must be taken into account when minimizing the risks of thermal effluents entering the intake channel of the Permskaya TPP.