We report a miniature hydrogen sensor that consists of a sub-wavelength diameter tapered optical fiber coated with an ultra thin palladium film. The optical properties of the palladium layer changes when the device is exposed to hydrogen. Consequently, the absorption of the evanescent waves also changes. The sensor was tested in a simple light transmission measurement setup that consisted of a 1550 nm laser diode and a photodetector. Our sensor is much smaller and faster than other optical hydrogen sensors reported so far. The sensor proposed here is suitable for detecting low concentrations of hydrogen at normal conditions.

We report a simple and compact modal interferometer for applications in refractometry. The device consists of a stub of large-mode-area photonic crystal fiber (PCF) spliced between standard single-mode fibers. In the splice regions the voids of the PCF are fully collapsed, thus allowing the coupling and recombination of PCF core and cladding modes. The device is highly stable over time, has low temperature sensitivity, and is suitable for measuring indices in the 1.330–1.440 range. The measure of the refractive index is carried out by monitoring the shift of the interference pattern.

Aircraft structures require periodic and scheduled inspection and maintenance operations due to their special operating conditions and the principles of design employed to develop them. Therefore, structural health monitoring has a great potential to reduce the costs related to these operations. Optical fiber sensors applied to the monitoring of aircraft structures provide some advantages over traditional sensors. Several practical applications for structures and engines we have been working on are reported in this article. Fiber Bragg gratings have been analyzed in detail, because they have proved to constitute the most promising technology in this field, and two different alternatives for strain measurements are also described. With regard to engine condition evaluation, we present some results obtained with a reflected intensity-modulated optical fiber sensor for tip clearance and tip timing measurements in a turbine assembled in a wind tunnel.

The authors report a highly sensitive $(\sim 2.8\mathrm{pm}∕\mu \epsilon )$ wavelength-encoded strain sensor made from a piece of photonic crystal fiber (PCF) spliced to standard fibers. The authors intentionally collapse the PCF air holes over a short region to enlarge the propagating mode of the lead-in fiber which allows the coupling of only two modes in the PCF. The transmission spectrum of the interferometer is stable and sinusoidal over a broad wavelength range. The sensor exhibits linear response to strain over a large measurement range, its temperature sensitivity is very low, and for its interrogation a battery-operated light emitting diode and a miniature spectrometer are sufficient.

A simple, compact, and low-cost optical fiber refractive-index (RI) sensor is reported. It consists of a multimode fiber in which a short section of standard single-mode fiber (SMF) is inserted. Owing to the core diameter mismatch, the cladding of the SMF guides light. This makes the device sensitive to the external RI. The maximum resolution of the sensor is about 7times10^-5. The fabrication of the sensor only requires cleaving and fusion splicing; moreover, the device can operate at different wavelengths, which makes it attractive for diverse applications