We show that a simple first-principles correction based on the difference between the singlet-triplet CO excitation energy values obtained by density-functional theory (DFT) and high-level quantum chemistry methods yields accurate CO adsorption properties on a variety of metal surfaces. We demonstrate a linear relationship between the CO adsorption energy and the CO singlet-triplet splitting, similar to the linear dependence of CO adsorption energy on the energy of the CO orbital found recently [Kresse et al., Phys. Rev. B 68, 073401 (2003)]. Converged DFT calculations underestimate the CO singlet-triplet excitation energy whereas coupled-cluster and configuration-interaction (CI) calculations reproduce the experimental The dependence of on is used to extrapolate for the top, bridge, and hollow sites for the (100) and (111) surfaces of Pt, Rh, Pd, and Cu to the values that correspond to the coupled cluster and CI value. The correction reproduces experimental adsorption site preference for all cases and obtains in excellent agreement with experimental results.
Theoretical ab initio and experimental methods are used to investigate the solid solution. We find that hybridization between Zn and and O orbitals allows the formation of short, covalent Zn-O bonds, enabling favorable coupling between -site and -site displacements. This leads to unusually large polarization, strong tetragonality, and an elevated ferroelectric to paraelectric phase transition temperature.
26 February 2016 in The Journal of Physical Chemistry C
We report an ab initio thermodynamic analysis of the $\alpha${}-Al2O3$\hskip0.3em${}(11\ifmmode\bar\else\textasciimacron\fi{}02) surface aimed at understanding the experimentally observed terminations over a range of surface preparation conditions as well as a stoichiometric model for the (2\ifmmode\times\else\texttimes\fi{}1) surface reconstruction observed after high-temperature annealing. As temperature is increased under both ultrahigh vacuum and ambient hydrated conditions, the predicted minimum-energy structural model goes through the same series of changes: from the hydroxylated ``missing-Al'' surface model (or half-layer model in which the topmost Al site of the stoichiometric surface has zero occupancy), to the hydroxylated stoichiometric model, to another hydroxylated missing-Al surface model with tetrahedral coordinated surface Al, and finally to the clean (1\ifmmode\times\else\texttimes\fi{}1) stoichiometric model. These results are in agreement with observations of both missing-Al and bulklike stoichiometries under wet conditions and in agreement with similar trends reported for isostructural hematite. However, we observe that the models with excess oxygen have a relatively higher surface-free energy and distinct surface relaxations in the case of alumina as compared to hematite. At very high temperatures where oxygen defects are generated, we find that a stoichiometric, charge-neutral (2\ifmmode\times\else\texttimes\fi{}1) structure becomes the most thermodynamically stable. This is consistent with the observation of a (2\ifmmode\times\else\texttimes\fi{}1) electron diffraction pattern when the surface is annealed at 2000 K while a (1\ifmmode\times\else\texttimes\fi{}1) pattern persists at lower annealing temperatures. A general rule that emerges from our modeling results is that while the full phase space of hydrated and defective surfaces is expansive, model stoichiometries that can be made charge neutral through either hydration or defects offer the greatest thermodynamic stability. However, the unique trends in structure and relative energies of alumina surface stoichiometries as compared to hematite can be understood based on the difference in electronic structure of the substrate.