Disc stack centrifuge belongs to one kind of sedimentation centrifuge, widely used in the environmental protection, pharmacy, and chemical industries, etc. The flow process inside the disc stack centrifuge seriously affects the separation efficiency. However, the flow process inside the disc stack centrifuge and its influence on the separation efficiency have not yet been detailed. We plan to study the flow process of oil and water phases inside the disc stack centrifuge and to explore the process of fragmentation and accumulation of water droplets. In this study, the Mixture-PBM (Population Balance Model) model is used to numerically simulate the two-phase flow of oil and water in the disc stack centrifuge and compare it with the tests. The research found that with the increase in rotational speed, the separation efficiency rises in both the test and numerical simulation results, and the difference between the test and simulation results is below 1%. The effect of ribs on the flow is considered, and the results show that the hysteresis of the liquid flow in the disc stack centrifuge is significantly reduced after considering the ribs, and the numerical simulation results can reach 98% of the theoretical results. Fluid entering the separation channel from the neutral pore creates a vortex, and as the dimensionless number λ increases, the degree of deviation of the fluid’s trajectory from the generatrix increases. The circumferential and radial velocities in the separation channel appear large in the center and small near the wall. The water content in the rising channel gradually decreases, and 90% of the water finishes settling in the distributor. The processing volume of the separation channel in each layer shows a small bottom layer, a large top layer, and a uniform law in the middle. The coalescence of water droplets occurs mainly in the separation channel, as found by analyzing the laws of the internal flow of the disc stack centrifuge, which provides the basis for improving the structure of the disc stack centrifuge, increasing the separation efficiency and reducing the floor space.
Taking a four-stage transonic compressor as the research object, the Lagrange particle tracking method was used to simulate the multiphase flow by considering the particle fragmentation, collision and evaporation models, and the influence of different inlet conditions (raindrop diameter, velocity, temperature and flow rate) on the compressor’s performance and stable working range was studied. The results show that inlet rain absorption can weaken the clearance leakage vortex make the shock wave move downstream, thus increasing the inlet flow rate, resulting in a decrease in stability margin and the highest efficiency point moving in the direction of flow increase. With the decrease in raindrop diameter, the pressure ratio and wet compression efficiency increase, and the stability margin decreases. With the increase in inlet raindrop velocity, the degree of pneumatic breakage increases and the raindrop diameter becomes smaller, which leads to the decrease in pressure ratio and efficiency. The influence of the mass flow rate of imported raindrops on the stable working range is significant. When the mass flow rate of imported raindrops accounts for 5% of the design flow, the stable working range can be reduced by more than half. Rain absorption increases the reaction force of the compressor and increases the load of the rotor blade.