The stainless steel SS-304 is used to produce turbine blades in some of the hydraulic power plants. It has excellent corrosion resistance and forming characteristics. In the present investigation, the nickel based clads were developed through microwave energy using domestic microwave oven equipped with 900W power at 2.45GHz frequency. The developed clads were characterized through optical metallography, scanning electron microscope (SEM), energy dispersive X-ray spectroscopy (EDS), X-ray diffraction (XRD) and porosity. Microstructure study revealed that microwave clads are free from visible interfacial cracks and porosity is significantly less at approximately 0.87%. The various complex metal carbides and intermetallics were found through XRD analysis. The distribution of metal carbides and intermetallics are the clearest indication for the improvement of hardness. The average microhardness of the developed clad surface is 364±70HV
In the present investigation microwave processing method was explored for the enhancement of surface properties of austenitic stainless steel (SS-304). The nickel based clads were developed through microwave energy. Taguchi's L9 orthogonal array was successfully adapted to study the slurry erosive wear rate. The obtained result indicated that erosion rate of the developed clad varied between 0.03363mgs to 0.03570 mgs as an increase in slurry parameters like slurry velocity and impingement angle respectively. It is confirmed by the response table for Means of DOE that the wear rate of the developed clad was more influenced by the rotational slurry speed and impingement angle; finally the possible mechanisms of the worn surface of the tested samples were observed through SEM.
A typical ferrite/martensitic heat-resistant steel (T91) is widely used in reheaters, superheaters and power stations. Cr3C2-NiCr-based composite coatings are known for wear-resistant coatings at elevated temperature applications. The current work compares the microstructural studies of 75 wt% Cr3C2- 25 wt% NiCr-based composite clads developed through laser and microwave energy on a T91 steel substrate. The developed clads of both processes were characterized through a field emission scanning electron microscope (FE-SEM) attached with energy-dispersive X-ray spectroscopy (EDS), X-ray diffraction (XRD) and assessment of Vickers microhardness. The Cr3C2-NiCr based clads of both processes revealed better metallurgical bonding with the chosen substrate. The microstructure of the developed laser clad shows a distinctive dense solidified structure, with a rich Ni phase occupying interdendritic spaces. In the case of microwave clad, the hard chromium carbide particles consistently dispersed within the soft nickel matrix. EDS study evidenced that the cell boundaries are lined with chromium where Fe and Ni were found inside the cells. The X-ray phase analysis of both the processes evidenced the common presence of phases like chromium carbides (Cr7C3, Cr3C2, Cr23C6), Iron Nickel (FeNi3) and chromium-nickel (Cr3Ni2, CrNi), despite these phases iron carbides (Fe7C3) are observed in the developed microwave clads. The homogeneous distributions of such carbides in the developed clad structure of both processes indicated higher hardness. The typical microhardness of the laser-clad (1142 ± 65HV) was about 22% higher than the microwave clad (940 ± 42 HV). Using a ball-on-plate test, the study analyzed microwave and laser-clad samples' wear behavior. Laser-cladding samples showed superior wear resistance due to hard carbide elements. At the same time, microwave-clad samples experienced more surface damage and material loss due to micro-cutting, loosening, and fatigue-induced fracture.