Most theoretical models of shallow anchor cables do not take the effect of anchor inclination into consideration, which is an important factor influencing load distribution, stress concentration, and failure mechanisms. In this paper, a modified bearing capacity was developed for a single anchor cable, taking the anchor inclination into consideration, based on the principle of limit equilibrium. Then, a series of indoor pull-out tests of single anchors with different inclinations were performed, where the effects of the anchor inclination on the bearing capacity and failure mechanisms were carefully analyzed. The experimental bearing capacities were compared to the predicted data of the proposed modified model, as well as other existing experimental results, aiming to verify the applicability and accuracy. The results show that the bearing capacity increases with decreasing anchor inclination because the vertical component of the force acting on the anchor cable increases. The failure models of the anchor cables, pulled out at different angles, exhibit an asymmetric “inverted trumpet” shape, which is caused by the varying stress distributions around the anchor cable during pull-out. In addition, the bearing capacities of the theory differ very little from the experimental and previous results, with a max error of nearly 10%. This study confirms that the proposed model reliably captures the effects of anchor inclination, providing valuable insights for designing inclined anchors in engineering practice.
19 July 2025 in Geotechnical and Geological Engineering
Since anchoring technology is a key measure to enhance the deformation resistance of engineering structures, it is widely applied in bridges, dams, power transmission lines, and offshore platforms. The displacement of anchor bolts directly affects the deformation resistance of structures, and anchor bolts are frequently arranged at an inclination angle in engineering practice—this inclination angle significantly affects their displacement. However, existing anchor bolt displacement prediction models do not account for the influence of inclination angles. To address this gap, a novel displacement prediction model for inclined anchor bolts based on Mindlin’s solution is proposed in this paper. The validation with three experimental datasets shows that the model’s relative errors are within 5%. Even if minor measurement uncertainties regarding input parameters exist in practical engineering scenarios, the calculated displacement results will not undergo significant deviations. The anchor bolt displacement prediction model proposed in this paper may help scholars better understand the relationship between anchor bolt inclination angle and displacement.