To identify the discharge features of tungsten inert gas (TIG) welding arc on magnesium alloy workpiece, spectral diagnosing and a self-developed Langmuir probe detection were jointly performed on the welding arc. Results show that during welding, Mg atoms with low ionization energy rush into the burning arc and replace Ar atoms to discharge, which gives influences on arc discharge. The arc plasmas have a normal space potential distribution. Reflected by both of the two diagnosing methods, region near arc anode (magnesium alloy workpiece) has the lowest electron temperature and the highest electron density. The variations of electron temperature and density with the position have similar trends measured by the two diagnosing methods, indicating that the self-developed probe detection system is effective and reliable in diagnosing the welding arc. It is also found that the diagnosing error of probe detection is a little larger than that of spectral diagnosing, especially in the region near cathode. This research gives a new method to diagnose the welding arc, and the results can give experimental indication and support to researchers in arc welding area from another view sight.
1 June 2024 in Science and Technology of Welding and Joining
In this study, continuous laser beam welding (CLBW) and tungsten-inert-gas (TIG) welding were employed to weld β-Ti dendrite-toughened metal glass composite with TC4 titanium alloy. The microstructure, element distribution, and mechanical properties of the welded joints were studied. The influence of the welding heat source state and welding speed on the crystallisation of the joints was analysed. The results revealed that at the interface between the fusion zone (FZ) and the Ti alloy, columnar crystals of β-Ti grew positively and extended from the Ti alloy into the FZ. The development of β-Ti grains was more pronounced during TIG welding than during CLBW owing to the lower cooling rate of the liquid pool in TIG welding. The hardness in the FZ of the TIG-welded sample was lower than that of the CLBW sample.
Welding experiments of high strength steel plate produced by Baosteel with IPG YLR-6000-ST2 fiber laser and Slab CO2 laser have been processed. The differences of laser in practical application have been investigated through the contrast of parameters and welding seam dynamic performances. It is showed that the maximum welding speed of fiber laser is 2∼3 times faster than Slab CO2 laser; the welding speed of fiber laser with the power 1300W is as same as Slab CO2 laser 3500W; the samples prepared by fiber laser have better depth-to-width ratio; the fit-up gap adjustability of fiber laser is better than Slab CO2 laser.