In this study, we analyze the accuracy of the stellar occultation technique to detect the oxygen number density and temperature in near space. Based on the validation of the algorithm related to stellar occultation using a single wavelength of 762 nm, the simulation and inversion are performed using the oxygen absorption A-band, and the results are compared with SABER observations to calculate the deviation. Then, the distribution of the detection accuracy with wavelength, latitude, and altitude is analyzed. The results show that the radiant transmittance of the basic observation varies significantly with wavelength and altitude, and it is not sensitive to a change of latitude. The inversion results of each wavelength at different latitudes can be combined, and it can be seen that the 754–769 nm band is preferred for oxygen and temperature detection. Therefore, analyzing the accuracy results of the specific wavelength 757.84 nm at different latitudes, the temperature accuracy can reach 0.1 K in the stratosphere at both low and high latitudes and 0.6–34 K at middle latitudes. The temperature detection accuracy in the mesosphere at each latitude reaches about a dozen K. The deviation of the inversion results at middle latitudes is larger in the thermosphere, and at the other two latitudes, it is about a few dozen K. From the analysis of relative deviation, excluding the deviation of 95–100 km, the deviation of other altitudes is within the ideal range, and the minimum can reach 0. The accuracy of the oxygen number density increases with latitude, and the relative deviation of the middle and high latitudes is around 10–20%. Based on the above results, it is concluded that the technique of starlight occultation exhibits high accuracy for detecting atmospheric parameters in the near space region, and the results lay the technical foundation for the independent development of stellar occultation.

This paper introduces a novel technique that uses observation data from GNSS to estimate the ionospheric vertical total electron content (VTEC) using the Kriging–Kalman method. The technique provides a method to validate the accuracy of the Ionospheric VTEC analysis within the Equatorial Ionization anomaly region. The technique developed uses GNSS VTEC alongside solar parameters, such as solar radio flux (F10.7 cm), Disturbance Storm Time (Dst) and other data, and Long Short Term Memory (LSTM) Networks to predict the occurrence time of the ionospheric equatorial anomaly and ionospheric VTEC changes. The LSTM method was applied to GNSS data from Haikou Station. A comparison of this technique with the neural network (NN) model and International Reference Ionosphere model shows that the LSTM outperforms all of them at VTEC estimation and prediction. The results, which are based on the root mean square error (RMSE) between GNSS VTEC and GIM VTEC outside the equatorial anomaly region, was 1.42 TECU, and the results of GNSS VTEC and VTEC from Beidou geostationary orbit satellite, which lies inside the equatorial ionization anomaly region, was 1.92 TECU. The method developed can be used in VTEC prediction and estimation in real time space operations.

The temporal variations and spatial variations in the ionosphere during geomagnetic storms are exceptionally complex and drastic, significantly complicating ionospheric model construction. In this study, we present a multi-site, high-precision ionospheric vertical total electron content ($VTEC$) estimation method by constraining the $VTEC$ when the locations of ionospheric pierce points (IPPs), determined by multiple sites, are nearby. The root mean square error (RMSE) relative to the global ionospheric map (GIM) $VTEC$ is 3.22 TEC units (TECU), with a correlation coefficient of 0.98. This method enables the high-precision estimation of $VTEC$ at IPPs. Utilizing the Gauss–Markov Kalman filter data assimilation algorithm, we consider the relationship between various Dst indices and the ionospheric temporal scales, achieving a regional ionospheric total electron content $\left(TEC\right)$ Map during geomagnetic storms. This approach effectively monitors the impact of geomagnetic storms on the ionospheric total electron content $\left(TEC\right)$ and provides a more accurate representation of ionospheric changes during geomagnetic storms compared to the GIM $TEC$ Map and the International Reference Ionosphere (IRI)-2020 model.

This study provides an in-depth analysis of the characteristics of stellar occultation events. Using 10 target star sources, the influence of orbital elements on the number, duration, and distribution of stellar occultation events was simulated and analyzed, and the constellation configuration was designed. The results showed the following points: (1) the orbital inclination had the greatest influence on the number of occultation events, with obvious upward and downward trends in the range of 10–40° and 150–180°, and the amount of occultation data remained at about 303 times under the other angle conditions. The orbital height had an effect on the number of occultations, but the amplitude was small. (2) The use of four orbits had an impact on the occultation duration. The duration decreased with an increase in the orbit height and inclination, the distribution was symmetrical with the perigee angular distance, and it increased with an increase in the ascending intersection right ascension. (3) The higher the orbital height, the less comprehensive the longitudinal and latitudinal distribution of occultation events. With an orbital inclination of less than 150°, the greatest occultation event was covered to encompass the entire world. The other two orbital elements had negligible effects on the longitudinal and latitudinal distribution of occultation events. (4) The elevation of the occultation event increased with an increase in the orbital altitude, but the azimuth showed no obvious change trends. A considerable number of normal occultations can be obtained with an orbital inclination of less than 120°. The other two orbital elements had a negligible effect on the distribution of altitude and azimuth of occultation events. A stellar occultation constellation configuration was designed based on the simulation results, and the results showed that the following parameters of satellites can be used to realize the global distribution of occultation events: orbital height of 500 km, orbital inclination of 97.3771°, perigee angular distance of 40°, and ascending node right ascension steps of 40°. This configuration will ensure that an adequate number of normal occultations are obtained, which will ensure the quality of data inversion under the condition of 152 infrared target star sources.

This study developed machine learning models using different algorithms, including support vector machine (SVM), random forest (RF), and backpropagation neural network (BPNN), to estimate the critical frequency of the F2 layer (foF2) and the maximum usable frequency of the F2 layer for a 3000 km circuit (MUF(3000)F2) based on the total electron content (TEC) observed by global navigation satellite system (GNSS) receivers. The ionospheric dataset used comprised TEC, foF2, and MUF(3000)F2 measurements from 11 stations in China during a solar activity period (2008–2020). The results indicate that all three machine learning models performed better than the IRI-2020 model, with varying levels of accuracy. For foF2 (MUF(3000)F2) estimation, the root mean square error (RMSE) values at Kunming and Xi’an stations were reduced by approximately 38% (26%) and 18% (11%), respectively, compared to IRI-2020. During geomagnetic disturbances, all three models were able to reproduce the variations in both foF2 and MUF(3000)F2 parameters. Nevertheless, the RF model showed significantly better performance in foF2 estimation compared to the SVM and BPNN models.

To address the challenge of microwave radiometer modeling in regions lacking radiosonde data, this study proposes a neural network retrieval method based on high-resolution the Final Reanalysis (FNL) reanalysis data and validates its feasibility. A microwave radiometer brightness temperature–profiles retrieval model was developed by the Back Propagation (BP) neural network, based on FNL reanalysis data from Qingdao, China. The model’s accuracy was evaluated by comparing retrieval results with synchronous radiosonde data, with an analysis of seasonal variations. Results indicate that the Root Mean Square Error (RMSE) of temperature profiles are 1.15 °C in the near-surface layer (0–2 km) and 2.05 °C in the mid-to-upper layers (>2 km). The comprehensive RMSE for relative humidity, water vapor density, and Integrated Water Vaper (IWV) are 17.27%, 0.96 g/m³, and 1.37 mm, respectively. Overall, the errors are relatively small, and the retrieval results exhibit strong spatiotemporal consistency with radiosonde data. The error increases most rapidly within the lower atmosphere (<2 km), with distinct seasonal differences observed. Temperature and relative humidity retrieval accuracies peak in summer, whereas water vapor density and IWV retrievals perform best in winter and worst in summer. This study confirms that reanalysis data–based modeling effectively addresses the issue of limited radiosonde coverage. This method is applicable to atmospheric remote sensing in regions lacking radiosonde data, such as oceans and plateaus. It provides a feasible solution to the regional limitations of microwave radiometer applications and expands the potential uses of reanalysis data.