The rapid expansion of lithium-ion battery (LIB) markets for electric vehicles and renewable energy storage has exponentially increased lithium demand, driving research into sustainable extraction methods. Traditional lithium recovery from brine using evaporation ponds is resource intensive, consuming vast amounts of water and causing severe environmental issues. In response, Direct Lithium Extraction (DLE) technologies have emerged as more efficient, eco-friendly alternatives. This review explores two promising electrochemical DLE methods: Electrodialysis (ED) and Capacitive Deionization (CDI). ED employs ion-exchange membranes (IEMs), such as cation exchange membranes, to selectively transport lithium ions from sources like brine and seawater and achieves high recovery rates. IEMs utilize chemical and structural properties to enhance the selectivity of Li⁺ over competing ions like Mg²⁺ and Na⁺. However, ED faces challenges such as high energy consumption, membrane fouling, and reduced efficiency in ion-rich solutions. CDI uses electrostatic forces to adsorb lithium ions onto electrodes, offering low energy consumption and adaptability to varying lithium concentrations. Advanced variants, such as Membrane Capacitive Deionization (MCDI) and Flow Capacitive Deionization (FCDI), enhance ion selectivity and enable continuous operation. MCDI incorporates IEMs to reduce co-ion interference effects, while FCDI utilizes liquid electrodes to enhance scalability and operational flexibility. Advancements in electrode materials remain crucial to enhance selectivity and efficiency. Validating these methods at the pilot scale is crucial for assessing performance, scalability, and economic feasibility under real-world conditions. Future research should focus on reducing operational costs, developing more durable and selective electrodes, and creating integrated systems to enhance overall efficiency. By addressing these challenges, DLE technologies can provide sustainable solutions for lithium resource management, minimize environmental impact, and support a low-carbon future.

The purpose of this study is to compare the spectral indices for a two-dimensional river algae map using an unmanned aerial vehicle (UAV) and an unmanned surface vehicle (USV) hybrid system. The UAV and USV hybrid systems can overcome the limitation of not being able to effectively compare images of the same region obtained at different times and under different seasonal conditions, when using a method of comparing and analyzing with absolute values in remote sensing. Radiometric correction was performed to minimize the interference that could distort the analysis results of the UAV imagery, and the images were taken under weather conditions that would minimally affect them. Three spectral indices, namely, normalized difference vegetation index (NDVI), normalized green–red difference index (NGRDI), green normalized difference vegetation index (GNDVI), and normalized difference red edge index (NDRE) were compared for the chlorophyll-a images. In field application and correlational analysis, the NDVI was strongly correlated with chlorophyll-a (R² = 0.88, p < 0.001), and the GNDVI was moderately correlated with chlorophyll-a (R² = 0.74, p < 0.001). As a result of comparing the chlorophyll-a concentration with the in-situ chlorophyll-a imagery by UAV, we obtained the RMSE of NDVI at 2.25, and the RMSE of GNDVI at 3.41.

Taste and odor (T&O) compounds present in natural water bodies could originate from algae. In this study, alga-generated compounds that can cause T&O issues in water, such as geosmin (GE), 2-Methylisoborneol (MIB), 2,4,6-Trichloroanisole (TCA), 2-Methylbenzofuran (MB), 2-Isopropyl-3-methoxypyrazine (IPMP), 2-Isobutyl-3-methoxypyrazine (IBMP), cis-3-Hexenyl acetate (HA), trans,trans-2,4-Heptadienal (HD), trans,cis-2,6-Nonadienal (ND), and trans-2-Decenal (DN), were determined through solid-phase microextraction coupled with gas chromatography/mass spectrometry (HS-SPME GC/MS) and electronic tongue (E-tongue), and the results from the two techniques were compared. Although HS-SPME GC/MS facilitates the detection and quantification of T&O compounds with high precision and accuracy, the sample preparation and handling is difficult and the analysis time (1 h) is longer than those of other analytical methods. E-tongue can be used as an alternative analytical method for water quality analysis and risk management because it enables controlled and rapid analysis (3 min) of T&O compounds in water at a low cost. Notably, principal component analysis indicated that E-tongue can discriminate and quantify eight T&O compounds at as low as 0.02 μg L^-1 concentration. Further, partial least squares analysis confirmed that the sensor exhibits high sensitivity to concentration changes. The sensors with the highest variable importance in projection scores were determined to be SCS (1.39 and 1.38) for GE and MIB, CTS (1.34) for IPMP, CPS (1.33) for IBMP, AHS (1.42) for HA, ANS (1.22) for HD, and NMS (1.14 and 1.19) for ND and DN.

Trace organic contaminants (TrOCs), including pharmaceutically active compounds (PhACs), present significant challenges for conventional water treatment processes and pose potential risks to environmental and human health. To address these issues, nanofiltration (NF) and reverse osmosis (RO) membrane technologies have gained attention. This study aims to evaluate the performance of NF and RO membranes in removing TrOCs from wastewater and develop a predictive model using the Solution Diffusion Model. Experiments were conducted using a stirred cell setup at various target concentrations, stirring speeds, and operating pressures, with acetaminophen and caffeine selected as representative pharmaceutical compounds. The results demonstrated that most of the pharmaceutical compounds were effectively removed, showing excellent performance. NF membranes exhibited high permeate flux with somewhat lower removal efficiency (average 84.17%), while RO membranes demonstrated high removal efficiency (average 99.21%), highlighting their importance in trace pharmaceutical treatment. The predictive model based on the solution diffusion model correlated well with the experimental data, suggesting its potential utility for large-scale system applications. This study confirms that NF and RO membranes are effective technologies for the removal of TrOCs from wastewater, offering a promising solution to the challenges posed by trace pharmaceutical contaminants.

The consistent quality control of ultrapure water (UPW) in semiconductor manufacturing depends on removing trace organonitrogen compounds such as urea. Due to its high solubility, chemical stability, and neutral polarity, urea is inadequately removed by conventional processes. Even at low concentrations, it elevates total organic carbon (TOC) and reduces electrical resistivity. The use of reclaimed water as a sustainable feed stream amplifies this challenge because its nitrogen content is variable and persistent. Conventional methods such as reverse osmosis, ultraviolet oxidation, and ion exchange remain limited in treating urea due to its uncharged, low-molecular-weight nature. This review examines the performance and limitations of these processes and explores electrochemical oxidation (EO) as an alternative. Advances in EO are analyzed with attention to degradation pathways, electrode design, reaction selectivity, and operational parameters. Integrated systems combining EO with membrane filtration, adsorption, or chemical oxidation are also reviewed. Although EO shows promise for selectively degrading urea, its application in UPW production is still in its early stages. Challenges such as low conductivity, byproduct formation, and energy efficiency must be addressed. The paper first discusses urea in reclaimed water and associated removal challenges, then examines both conventional and emerging treatment technologies. Subsequent sections delve into the mechanisms and optimization of EO, including electrode materials and operational parameters. The review concludes with a summary of main findings and a discussion of future research directions, aiming to provide a comprehensive foundation for validating EO as a viable technology for producing UPW from reclaimed water.

Urban water systems are essential infrastructure but significantly contribute to greenhouse gas emissions through their operation. This study analyzed the greenhouse gas emissions of Incheon’s water system and proposed effective reduction strategies. In 2021, total greenhouse gas emissions from Incheon’s water system are 410,407 tCO₂eq, with the sanitation sector accounting for 82.1% and water supply for 17.9%. N₂O from wastewater treatment contributes 59.2% of total emissions, followed by CO₂ (36.6%) and CH₄ (4.2%). Sensitivity analysis using system dynamics identified per capita water consumption (LPCD) reduction as the most impactful mitigation strategy, surpassing widely adopted strategies such as renewable energy adoption. Scenario analysis showed that an aggressive policy could reduce emissions by 28.8% by 2050 compared to the baseline scenario. These findings provide a decision-making policy for carbon-neutral urban water management, emphasizing the need for integrated approaches to water management, emphasizing water demand reduction, energy efficiency, and sludge management.