In this paper, we propose a Y-type dual-mode microstrip phase shifter that utilizes input–output cross-coupling. The structure comprises a main line and a reference line, with the main line designed in a cross-coupled parallel-feeding configuration to create a band-pass filter. The single-mode resonance frequency is fine-tuned to meet the bandwidth requirements of the band-pass filter. Additionally, by introducing new symmetric transmission zeros in the upper and lower cutoff bands through the cross-coupling of the input and output feed lines, we achieve a quasi-elliptic response. This design significantly enhances both the passband and out-of-band performance of the filter. The reference line functions as a uniform transmission line, and the phase shift value of the phase shifter is achieved by adjusting its electrical length. Compared to conventional phase shifters, this design offers several advantages, including a simpler structure, reduced phase error, and a wider phase shift range. Ultimately, a 90° to 225° phase shifter was designed and simulated, while a 90° phase shifter was fabricated and tested. Measurement results indicate that the designed phase shifter successfully achieves a phase shift of 90° ± 1.2°, with S11 less than 16.5 dB and a fractional bandwidth (FBW) of 60.8%.
In this paper, a filtered differential phase shifter with good selectivity is proposed and constructed. This study proposes and builds a filtered differential phase shifter with good selectivity. The main and reference lines in the suggested filtered differential phase shifter are structurally identical. The main line’s bandpass filtering function is achieved by a new coupled feeder, a parallel coupled line loaded with shorted branches, and a coupled resonator at the load end. It has impedance matching and additional transmission zeros/poles. By loading the coupled resonator at the load end, the selectivity of the phase shifter can be improved and the passband and transmission zeros/poles of the phase shifter can be equitably distributed by varying the coupling coefficients and the electrical lengths of the loaded branches. The reference line is a coupled resonator with the same structure and its electrical length is related to the number of degrees of phase shift. Finally, a differential phase shifter is designed and measured. The fractional bandwidth of the proposed phase shifter is about 38%, the return loss reaches −11 dB, the insertion loss is about 1.02 dB, the deviation of the simulated results in terms of the number of degrees of phase shift is about 2.5 degrees, and the deviation of the tested results is about 6 degrees. The trend of the simulation results and the actual measurement results are in good agreement.