This study examined the dynamic instability of a drum brake induced by the rigid modes of the brake shoe. The brake shoe was modeled as a rigid curved plate subject to frictional contact with a rotating drum. In the presence of a negatively sloped friction curve, dynamic instability was numerically analyzed with respect to variation in the system parameters. The results showed that mode-coupling instability did not occur, but dynamic instability was induced by negative damping in a specific rigid mode, and its propensity varied with the operating conditions and geometric changes.
This study proposes a new wheel-leg mechanism concept and formulations for the kinematics and dynamics of a stair-climbing robot utilizing the rotating leg locomotion of curved spokes and rolling tires. The system consists of four motor-driven tires and four curved-spoke legs. The curved-spoke leg is semicircle-like and is used to climb stairs. Once the spoke leg rolls on the surface, it lifts and pulls the mating wheel toward the surface, owing to the kinematic constraint between the spoke and the wheel. Single-wheel climbing is a necessary condition for the stair climbing of whole robots equipped with front and rear axles. This study proposes the design requirements of a spoke leg for the success of single-wheel climbing in terms of kinematic inequality equations according to the scenario of single-wheel climbing. For a design configuration that enables single-wheel climbing, the required minimum friction coefficient for the static analysis of the stair-climbing wheeled robots is demon-strated. Thereafter, the stair-climbing ability is validated through the dynamic equations that enable the frictional slip of the tires, as well as the curved-spoke legs. Lastly, the results revealed that the rotating locomotion of the well-designed curved-spoke legs effectively enables the stair climbing of the whole robot.
In this paper, the stability of the split doublet mode pair in a disc brake squeal is analytically investigated. A reduced-order doublet mode model is derived based on the formulation of annular plate vibration, sliding contact kinematics, and the assumed mode method. The solution is approximated using a two-mode expansion for the doublet mode pair. The time-varying motion of the slightly asymmetric rotating disc is described through the moving mode shape function method. A stability analysis of the frequency split between the doublet mode pair is performed by calculating the characteristic multipliers using the Floquet theory. The stability boundary is determined within the domain of frequency split variations and other parameters. Finally, the influence of mode splitting on the squeal behaviour of the asymmetric disc is analysed and discussed.