This study develops forest road recognition technology using deep learning-based image processing to support the advancement of autonomous driving technology for forestry machinery. Images were collected while driving a tracked forwarder along approximately 1.2 km of forest roads. A total of 633 images were acquired, with 533 used for the training and validation sets, and the remaining 100 for the test set. The YOLOv8 segmentation technique was employed as the deep learning model, leveraging transfer learning to reduce training time and improve model performance. The evaluation demonstrates strong model performance with a precision of 0.966, a recall of 0.917, an F1 score of 0.941, and a mean average precision (mAP) of 0.963. Additionally, an image-based algorithm is developed to extract the center from the forest road areas detected by YOLOv8 segmentation. This algorithm detects the coordinates of the road edges through RGB filtering, grayscale conversion, binarization, and histogram analysis, subsequently calculating the center of the road from these coordinates. This study demonstrates the feasibility of autonomous forestry machines and emphasizes the critical need to develop forest road recognition technology that functions in diverse environments. The results can serve as important foundational data for the future development of image processing-based autonomous forestry machines.

Logging operations comprise a repeated and tedious job in forestry operations because forestry forwarders must keep completing round-trip transportation on forest roads from tree-cutting sites to forest roads where their truck can be accessed. In this study, an autonomous driving system for tracked forwarders was developed using GNSS (Global Navigation Satellite System)/INS (Inertial Navigation System). The mechanical control system of the forwarder was replaced with an electronic control system, and path-planning and -tracking algorithms were implemented. The electronic control system, operated by servo motors to operate the driving levers, exhibited a response that was 150 milliseconds faster in lever control compared to manual operation. To generate an autonomous driving path, a skilled operator drove the forwarder along a forest road, and the recorded path was post-processed using the Novatel Inertial Explorer 8.70 GNSS + INS software to minimize GNSS errors. The autonomous forwarder followed the generated path using the pure pursuit algorithm. Autonomous driving tests conducted along this path achieved a root mean square error (RMSE) within 0.4 m (range: 0.389–0.393). Driving errors were primarily attributed to GNSS positional inaccuracies, especially in environments with dense canopies and landslide prevention structures located higher than the GNSS antenna, obstructing satellite signals. These findings underscore the importance and feasibility of autonomous forwarders in diverse forest environments, providing a critical foundation for advancing autonomous forestry machinery. The proposed technologies are expected to significantly contribute to enhancing the productivity of forestry operations.

In this study, a Wi-Fi system with a tethered balloon is proposed for the teleoperation of vehicular forestry machines. This system was developed to establish a Wi-Fi communication for stable teleoperation in a timber harvesting site. This system consisted of a helium balloon, Wi-Fi nodes, a measurement system, a global navigation satellite system (GNSS) antenna, and a wind speed sensor. The measurement system included a GNSS module, an inertial measurement unit (IMU), a data logger, and an altitude sensor. While the helium balloon with the Wi-Fi system was 60 m in the air, the received signal strength indicator (RSSI) was measured by moving a Wi-Fi receiver on the ground. Another GNSS set was also utilized to collect the latitude and longitude data from the Wi-Fi receiver as it traveled. The developed Wi-Fi system with a tethered balloon can create a Wi-Fi zone of up to 1.9 ha within an average wind speed range of 2.2 m/s. It is also capable of performing the teleoperation of vehicular forestry machines with a maximum latency of 185.7 ms.