This study aims to clarify the effect of density of riparian vegetation on effective tractive force for various bedload transport conditions. Hydraulic model experiments were performed using a straight channel, and the methods used to calculate the effective tractive force necessary for estimating bedload transport rate in channels with riparian vegetation were studied. An apparatus was developed to directly measure the effective tractive force in a channel with riparian vegetation. Applying the apparatus in a hydraulic experiment allowed accurate direct measurement of effective tractive force, formerly estimated indirectly. Based on the experimental results, the effect of the density of vegetation on the effective tractive force was examined. Then the methods for estimating effective tractive force and bedload transport rate were studied. As a result of the experiment, it was found that the coefficient of velocity U′/U′* and the ratio of coefficient of velocity (U′/U′*)/(U/U*) are negatively correlated with the density of vegetation. A very high negative correlation was also obtained between recession coefficient of effective tractive force (β = effective tractive force of a flow with riparian vegetation/effective tractive force of a flow with no riparian vegetation) and the density of vegetation. The friction factor of the channel bed f′ was positively correlated with the density of vegetation. Methods were presented for accurately estimating effective tractive force using equations including the relationships of the density of vegetation to the coefficient of velocity, the ratio of the coefficient of velocity, and the recession coefficient of effective tractive force. Using the estimated effective tractive force and an existing bedload equation enabled very accurate calculation of bedload transport rate in flows through riparian vegetation. The methods presented in this study have potential to be developed as a tool that can provide guidance in the planning and designing of riparian vegetation that are intended for the prevention and mitigation of floods and resultant sediment transportation.
Connectivity of landslide sediment to and within fluvial systems is a key factor affecting the extent of mobilization of hillslope material. In particular, the formation of landslide dams and the transformation into landslide-induced debris flows represent “end members” of landslide sediment mobility. To quantify sediment connectivity, we developed a two-segment flume representing tributary inflow and the main channel. Mobility of sediment was examined by combinations of various topographic factors, such as tributary inflow angle (0 to 90° in 30° increments) and main channel gradient (10° and 15°), as well as water content of sediment (0 to 100% in 20% increments). We also examined differences of mobility among sediments derived from various lithologies (sand and shale, pyroclastic sediment, weathered granite, and weathered sedimentary rock). Mobility of sediment differed, depending on the water content of sediment, particularly less than saturation or greater than saturation. When all types of unsaturated landslide sediments entered the channel at inflow angles of 60° and 90°, substantial deposition occurred, suggesting the formation of landslide dams. At low inflow angles (0° and 30°) in a steep channel (15°), >50% of landslide sediment was transported downstream, indicating the occurrence of a debris flow. The amount of sediment deposited at the junction angle was greater for pyroclastic sediment followed by weathered granite, weathered sedimentary rock, and finally, sand and shale. Our connectivity index suggests that a threshold exists between landslide dam formation and debris flow occurrence associated with topographic conditions, water content, and types of sediment.