This paper proposes a novel, two-stage and hybrid approach based on variational mode decomposition (VMD) and the deep stochastic configuration network (DSCN) for power quality (PQ) disturbances detection and classification in power systems. Firstly, a VMD technique is applied to discriminate between stationary and non-stationary PQ events. Secondly, the key parameters of VMD are determined as per different types of disturbance. Three statistical features (mean, variance, and kurtosis) are extracted from the instantaneous amplitude (IA) of the decomposed modes. The DSCN model is then developed to classify PQ disturbances based on these features. The proposed approach is validated by analytical results and actual measurements. Moreover, it is also compared with existing methods including wavelet network, fuzzy and S-transform (ST), adaptive linear neuron (ADALINE) and feedforward neural network (FFNN). Test results have proved that the proposed method is capable of providing necessary and accurate information for PQ disturbances in order to plan PQ remedy actions accordingly.

This paper presents a doubly fed induction generator (DFIG) wind power system with hydrogen energy storage, with a focus on its virtual inertia adaptive control. Conventionally, a synchronous generator has a large inertia from its rotating rotor, and thus its kinetic energy can be used to damp out fluctuations from the grid. However, DFIGs do not provide such a mechanism as their rotor is disconnected with the power grid, owing to the use of back-to-back power converters between the two. In this paper, a hydrogen energy storage system is utilized to provide a virtual inertia so as to dampen the disturbances and support the grid’s stability. An analytical model is developed based on experimental data and test results show that: (1) the proposed method is effective in supporting the grid frequency; (2) the maximum power point tracking is achieved by implementing this proposed system; and, (3) the DFIG efficiency is improved. The developed system is technically viable and can be applied to medium and large wind power systems. The hydrogen energy storage is a clean and environmental-friendly technology, and can increase the renewable energy penetration in the power network.

In the process of electric motor design, it is essential to predict and provide an accurate thermal and mechanical model. The aim of this research is to improve the thermal and mechanical performance—which is implemented into a 72/48 switched reluctance motor (SRM) with 75 kW—of a low-speed direct-drive mining system (pulverizer). Thermal analysis of the SRM requires a deep understanding of the coolant behavior and the thermal mechanism in the motor. Computational fluid dynamics (CFD) based finite element analysis (FEA) was carried out in order to precisely visualize and estimate fluid state and temperature distribution inside the motor. Several different coolant configurations were carried out, with the purpose of determining an appropriate one for uniform temperature distribution in the SRM. The natural frequencies are presented with the developed finite element mechanical, structural model. To adapt in the mining application, the cooling jacket configurations with 17 channels and the shaft with spoke was found to be optimal for the SRM, which may raise the natural frequency and reduce the weight and temperature of the motor. The simulations results showed a good agreement with experimental results regarding temperature distribution within the motor.

Harmonics and interharmonics in power systems distort the grid voltage, deteriorate the quality and stability of the power grid. Therefore, rapid and accurate harmonic separation from the grid voltage is crucial to power system. In this article, a variational mode decomposition-based method is proposed to separate harmonics and interharmonics in the grid voltage. The method decomposes the voltage signal into fundamental, harmonic, interharmonic components through the frequency spectrum. An empirical mode decomposition (EMD) and an ensemble empirical mode decomposition (EEMD) can be combined with the independent component analysis (ICA) to analyze the harmonics and intherharmonics. By comparing EMD-ICA, EEMD-ICA methods, the proposed method has several advantages: (1) a higher correlation coefficient of all the components is found; (2) it requires much less time to accomplish signal separation; (3) amplitude, frequency, and phase angle are all retained by this method. The results obtained from both synthetic and real-life signals demonstrate the good performance of the proposed method.