Municipal solid waste (MSW) permeability is influenced mainly by compaction, unit weight, overburden pressure, composition, and biodegradation of the waste. However, the variation of hydraulic conductivity with MSW biodegrading over time has not yet been sufficiently studied, and consequently not fully understood. This study aimed to present the saturated hydraulic conductivity ( ) of the MSW, considering the influence of anaerobic biodegradation, by using two large-scale rigid wall permeameters (P1 and P2) in two experimental groups. The leachate produced was subjected to physicochemical analysis. The MSW confined in both permeameters presented similar gravimetric composition and total mass but diverse initial unit weight, ranging from 4.9 to . Maximum and minimum values of obtained for the confined MSW were and , respectively. Physicochemical analysis indicated that MSW biodegradation in permeameters remained in the anaerobic acid phase. The methodology adopted for the permeability tests influenced the MSW biodegradation, and consequently its hydraulic behavior. It is believed that, during 7 days before the permeability tests, the drained gas changed the MSW mass structure into the permeameters and the values over time. Within the permeameters with higher unit weight MSW, the values increased for up to 3 months, tending to stabilization.
This paper presents the results of unconfined compressive strength tests performed in specimens properly prepared with plastic mixtures of soft soil, blast furnace slag cement, and water in laboratory conditions. These tests were performed to study the mixture of soil with cement for the treatment of soft clays in the region of Santos City, located in São Paulo State, Brazil. The aim of these mixtures was to obtain strength parameters that could be used in method Mass Stabilization - Dry-Mix, indicating the best cement content in order to run the service. This study involved the analysis of the results of increased unconfined compressive strength over time, using two different amounts of cement, 100 and 200 kg per cubic meter of soil, i.e., with percentages of 4.0% and 8.0% of cement by dry weight of the soil. The mixtures were prepared in accordance with experiences cited in international literature. Tests conducted at ages 7, 28 and 90 days showed significant changes with time, increasing the unconfined compressive strength, especially when it is used 200 kg of cement.