Current trends in the development of technology are linked inextricably to the increasing level of automation in technological processes and production systems. In this regard, the development of systems for supplying working fluids with adjustable pumps that have high performance characteristics, an increased service life and low operating costs is an important scientific and technical task. A primary challenge in the development of such systems lies in achieving low fluid flow rates while maintaining stable operating characteristics. This challenge stems from the fact that currently available controlled hydraulic pumps exhibit either a high cost or suboptimal life and efficiency parameters. This work focuses on the development of a plunger hydraulic pump with a small working volume. A mathematical model has been developed to investigate the characteristics, optimize the design of this pump and further expand the size range of such pumps. The solution was implemented on a computer using the dynamic modelling environment MATLAB/Simulink. In order to verify the mathematical model’s adequacy, a plunger pump prototype was built and integrated with a test bench featuring a measurement system. The test results showed higher pump efficiency and a significant reduction in hydraulic losses. An analysis of the obtained data shows that the pump is characterized by increased efficiency due to optimal flow distribution and reduced internal leakage, which makes it promising for use in hydraulic systems requiring improved operating characteristics. The developed pump has more rational characteristics compared to existing alternatives for use in water supply systems for induction superheaters. The experimental external characteristics of the developed pump are 10% higher than the external characteristics of the ULKA EX5 pump selected as an analogue, and the pressure characteristics are 65% higher. It offers production costs that are several times lower compared to existing cam-type plunger or diaphragm pumps with oil sumps and precision valve mechanisms. Additionally, it has significantly better operating characteristics and a longer service life compared to vibrating plunger pumps.
The article considers a method of controlling the motion of the output links of the tracking system of pneumatic actuators of technological equipment actuators. Dynamic and qualitative characteristics are improved by means of proportional-integral-differential (PID) controller. The mathematical model of actuator system, which includes power and control parts, has been developed. By calculation experiment the dynamic characteristics of the actuator have been obtained, from which it has been found possible to reduce the energy consumed by the actuator system to about 30%.
This study investigates the external load and positional constraints’ impact on the accuracy and performance of an autonomous adaptive electrohydraulic actuator with pump control intended for mobile equipment. An actuator simulation model was developed in the MATLAB/Simulink (version R2021A) environment, and a full-scale experimental setup was constructed to validate this model. Various motion trajectories under different load conditions were analyzed to evaluate discrepancies between simulated and experimental results and to identify key performance characteristics across operational modes. The results demonstrate that the simulation model adequately replicates the actuator’s dynamic behavior, although deviations emerge under high-load conditions. Notably, in the absence of external load, the static positioning error does not exceed 0.025 mm (0.05% of the 50 mm target value), while under the maximum load of 8000 N, the error increases to 0.075 mm (0.15% of the 50 mm target value). These limitations are primarily due to current constraints imposed by the actuator’s power supply capacity (up to 300 W at 24 V), which restrict pressure buildup rates under heavy loads. Nevertheless, the proposed control system exhibits robustness to load variations and ensures positioning accuracy within acceptable limits, demonstrating its practical suitability for mobile machinery applications. The developed simulation model also serves as a valuable tool for control system tuning and testing in the absence of a physical prototype.
The article is devoted to the modeling and simulation of the TDJT-101 wagon point retarder. The scope of work included the development of a mathematical model and the analysis of dynamic characteristics, which will reduce the time and cost of prototype development and improve the quality of point retarders by several times. The mathematical model includes the equations of motion and pressure. To solve the mathematical model, a calculating experiment was carried out and the dynamic characteristics were obtained.