It is difficult to automatically recognize defects using digital image processing methods in X-ray radiographs of lap joints made from plates of unequal thickness. The continuous change in the wall thickness of the lap joint workpiece causes very different gray levels in an X-ray background image. Furthermore, due to the shape and fixturing of the workpiece, the distribution of the weld seam in the radiograph is not vertical which results in an angle between the weld seam and the vertical direction. This makes automatic defect detection and localization difficult. In this paper, a method of X-ray image correction based on invariant moments is presented to solve the problem. In addition, a novel background removal method based on image processing is introduced to reduce the difficulty of defect recognition caused by variations in grayscale. At the same time, an automatic defect detection method combining image noise suppression, image segmentation, and mathematical morphology is adopted. The results show that the proposed method can effectively recognize the gas pores in an automatic welded lap joint of unequal thickness, making it suitable for automatic detection.
Destructive testing is a common method for obtaining tensile strength properties of welds. However, it is inconvenient to characterize the overall weld, and it cannot be applied to in-service structures. Non-destructive testing and evaluation (NDT&E) methods have the potential ability of overcoming these limitations. In this paper, an ultrasonic-based non-destructive evaluating method for weld tensile strength was proposed. Multiple sets of fully automatic welded X80 steel pipes were prepared. Acoustic signals from a total of 240 measurement points of the welds were collected, and ultrasonic characteristic parameters were subtracted through signal processing. Subsequently, tensile strength values were obtained through destructive testing. Using the ultrasonic and tensile test databases, a multivariate regression-based (MLR) non-destructive evaluation model was established to predict the tensile strength value. Based on this, in order to rapidly characterize the welds, a grading evaluation model was introduced. The grading evaluation result of the 240 measurement points indicates that the accuracy of the proposed method is 76.3%. In order to improve accuracy, a deep learning-based method could be used in the future.
It is difficult to automatically recognize defects using digital image processing method in X-ray radiograph that tested from lap joint of unequal thickness plates. The continuous change of the wall thickness for the lap joint workpiece bring s about the very different gray levels in X-ray background image. Besides, due to the shape and fixturing of the workpiece, the distribution of the weld seam in the radiograph is not vertical and results in an existence of a certain angle with the vertical direction. T his makes it difficult for automatic defect detection and localization. In this paper, a method of X-ray image correction based on invariant moments is presented to solve the problem. In addition, an automatic defect detection method combined of image noise suppression, background removal, image segmentation and mathematical morphology is introduced . The results show that the proposed method can effectively recognize the gas pores in lap joint of unequal thickness and it is suitable for automatic detection.