A slow slip event (SSE) and tectonic tremors occurred approximately 1.5 month prior to the occurrence of the 2011 Tohoku‐Oki earthquake near the Japan Trench. Although we cannot completely rule out other sources of noise near the observation site, slow earthquakes would demonstrate the nucleation of a fast slip event from prior slow earthquake activity. Here we report on tectonic tremor activity detected from short‐period ocean‐bottom seismometer (OBS) data with a modified frequency scanning method that allows robust tectonic tremor detection by incorporating information from multiple frequency passbands in order to suppress false detections. We have identified at least five tectonic tremor sequences on the OBS records from the end of January 2011 to just before the occurrence of the Tohoku‐Oki earthquake in March 2011. To reveal the spatial distributions of tectonic tremors before the Tohoku‐Oki earthquake, we then calculated tremor energy, with corrected site amplification, from the identified tectonic tremor time window at each OBS that detected tremors. Possible sources of tremors were distributed in trenchward side of the SSE fault prior to the main shock. These tremors could be modulated by SSE to take into account consistent timing between tremor and SSE term, and consistency of spatial locations between estimated tremor sources and SSE faults. This spatiotemporal pattern in tectonic tremor activity demonstrates a significant separation of occurrence sources between tectonic tremors and regular earthquakes.
23 January 2024 in Journal of Geophysical Research: Solid Earth
Various types of slow earthquakes (e.g., tectonic tremors and slow slip events) have been reported in tectonic zones, especially in the subduction zone. The tidal response of a tremor is considered to be strongly related to the weak friction state of the plate interface, and many studies have reported observational evidence of such correlation between tides and deep tremor activity. Here we used the modified frequency scanning method at a single station to detect micro tectonic tremors that have not been previously reported in southern Kyushu. In the early stage of the tremor activity, tremors are mostly modulated by slow slip events. In contrast, we found a seismic response to ocean tides during the later stage in the shallower part of the subduction zone. This might indicate that the tremors are triggered by tidal changes caused by fault weakening due to slow slip events as same as deeper condition.
31 December 2024 in Bulletin of the Seismological Society of America
Earthquake early warning (EEW) systems in Japan use data from as little as a single observation point, even at the stage in which only the P wave is detected at one point, to estimate the epicentral distance and magnitude to rapidly issue a warning. This approach aims to maximize lead time but has the drawback of significant estimation errors (epicentral distance: half to double, back azimuth: ±30°). Using distributed acoustic sensing (DAS) with a dense network of observation points allows for rapid and precise earthquake hypocenter determination, significantly reducing estimation errors compared to single-station methods in EEW system. However, no prior studies have investigated the immediacy of using DAS data—which is indispensable for early earthquake warnings. Therefore, we examined the use of DAS for rapid and precise hypocenter determination with the goal of integrating it into the EEW system. We used fiber-optic cables along the Kyushu Shinkansen to analyze strain-rate waveforms, detect P waves, and determine earthquake hypocenter locations. We detected P waves using short-term average /long-term average simultaneously across multiple channels. We then determined the epicenter using Hypomh. For rapid determination of the hypocenter location after P-wave detection, we assessed the hypocenter location each time the number of P-wave detection points increased by 20. For earthquakes with an epicentral distance of less than 50 km, we successfully determined the hypocenter within 12 km of the Japan Meteorological Agency-reported location. This was achieved by identifying the point where the sum of the maximum-likelihood estimation errors was minimized within 2 s of the initial P-wave detection in any channel. The findings suggest that an EEW system using DAS holds potential as a powerful tool to provide rapid and accurate hypocenter information, especially for near-field earthquakes that occur directly beneath populated areas, where lead times are short, and the potential damage is substantial.
2 June 2020 in Journal of Geophysical Research: Solid Earth
Dynamic triggering of large, detectable slow slip events (SSEs) is rarely observed, even though regional earthquakes often trigger tectonic tremors and very low frequency earthquakes. In this study, we investigate stress sensitivity of dynamic triggering of shallow SSEs in the Nankai Trough offshore of Kii Peninsula, Japan. We first identify additional shallow SSEs that have not been reported in previous studies and obtain a 15‐year‐long catalog of SSEs, some of which are triggered by passing seismic waves originating from large regional earthquakes. We then quantify dynamic and static stress perturbations on the plate interface induced by 19 candidate regional earthquakes using numerical simulations of seismic wave propagation. We find that SSE propensity to dynamic triggering depends mainly on the maximum Coulomb stress change and that relatively large dynamic stresses (>10–20 kPa) are needed to trigger a shallow SSE in the Nankai Trough. Regional earthquakes that can induce such large amplitude of dynamic stresses on the plate interface are relatively rare, which might explain the scarcity of dynamic triggering of large, detectable SSEs along the Nankai as well as other subduction zones. In addition, our analysis suggests that intraslab earthquakes can efficiently trigger SSEs in subduction zones via less‐attenuated, slab‐guided waves. Moreover, our results support the idea that an accretionary wedge in subduction zones promotes the dynamic triggering of shallow SSEs.
To enhance real-time S-wave detection in the railway earthquake early warning (EEW) system, we improved the existing short-term average/long-term average (STA/LTA) algorithm. This enhancement focused on developing a more robust and computationally efficient method. Specifically, we introduced noise reflecting P-wave amplitude information before the P-wave to better distinguish between P- and S-waves. By applying this modified STA/LTA method, we achieved a significant improvement in S-wave detection accuracy. For seismic waveforms from stations located within 100 km of the epicenter of each earthquake, with magnitude of M5.5–6.5 and depths ≤ 100 km, the detection accuracy within 1.5 s of the correct time (manual picking) was 81.0%, compared to the 49.0% accuracy of the currently operational railway EEW system. Importantly, despite the improved accuracy, the computational cost of the new method remains comparable to the existing system, allowing for easy integration into the operational EEW system. This development is crucial for preventing false alarms, especially moderate earthquakes (~M6) because issuing warn-ings in unnecessary areas can have a significant social impact. Future plans involve implementing this method into the current system to further improve early warning capabilities and minimize false alarms.