Grid-scale energy storage systems are of interest as the world increases reliance on renewable energy sources. Redox flow batteries are a type of grid-scale energy storage technology that shows exceptional promise for accommodating the dynamic output of wind and solar power sources. The research community employs dozens of diagnostic techniques to investigate nearly all facets of these devices. Material properties, operational losses, transport, and integrated system properties are studied through the lens of electrochemical, physical, and chemical phenomena that ultimately dictate cost by influencing efficiency, durability, power, and capacity. These diagnostic techniques can, if applied correctly, elucidate not only the types of losses in redox flow batteries, but also tie those losses to fundamental driving forces in such systems so that next generation systems and models can be designed. This review details various diagnostic techniques used in flow battery analysis. The benefits, unique insights, and limitations of these techniques are discussed. Recommendations are also made to assist researchers in identifying the diagnostics that can advance their particular investigations. The review concludes with a summary of opportunities for new diagnostics that are needed to enable solution of persistent issues in redox flow battery research and development.
An experimental method for measurement of local redox potential within multilayer electrodes was developed and applied to all-vanadium redox flow batteries (VRFBs). Through-plane measurement at the positive side reveals several important phenomena including potential distribution, concentration distribution of active species and the predominant reaction location within the porous carbon electrodes.
20 April 2011 in Journal of the Electrochemical Society
In this study, the effect of a controlled temperature gradient on water transport across a single fuel cell was quantitatively investigated using high-resolution neutron imaging. The direction of liquid water transport under isothermal and non-isothermal conditions was observed in both hydrophilic and hydrophobic diffusion media (DM). The change in distribution of liquid saturation with time revealed two different mechanisms of water transport; capillary driven flow and phase-change induced (PCI) flow, in which a water vapor concentration gradient is created by condensation at a colder location. This concentration gradient drives diffusion flow toward the colder location. A maximum liquid saturation plateau of ca. 30% was shown for all conditions tested, indicating a critical transition between pendular and funicular modes of liquid water storage was captured. Based on this, it is suggested that PCI-flow may be the main mode of liquid transport below this critical transition threshold, above which, capillary flow dominates. As expected, both average cell temperature and the magnitude of temperature gradient were shown to significantly affect the rate of condensation within the DM. Experimental results were compared with water saturation distribution model predictions from literature and show reasonable qualitative agreement. Finally, it was concluded that current available models significantly over predict vapor phase diffusive transport in saturated fuel cell media using a Bruggeman type model.