Boron oxide-based systems on structure and properties are similar to silicate systems, but they are more fusible and so are widely used in modelling various metallurgical processes. This paper presents the results of viscosity, electrical conductivity, surface tension and density measurements of the B2O3–CaO system with a content of 25–45% CaO in the temperature range above the liquidus temperature. To measure viscosity, vibration viscometry was used. Electrical conductivity was measured via the contact method using an alternating current bridge. Surface tension and density were measured using the lying drop method. The obtained results were used to describe the structure of borate melts.
The decarbonization of breunnerite from talc waste is analyzed by thermogravimetry. The temperatures of thermal effects are determined, and kinetic models for the process are proposed to describe the mechanism of breunnerite decomposition. The unit cell parameters of breunnerite (MgxFe1–x)CO3 and the product of its decomposition, iron–magnesium oxide (Mg,Fe)O, are calculated. The apparent activation energies Ea of the decomposition are calculated using the Ozawa–Flynn–Wall and Kissenger model-free methods and the Avrami–Erofeev one-step model. Depending on the chosen model, the values of Ea range within 180–185 kJ/mol. The conditions of breunnerite roasting for the subsequent use of the obtained material in metallurgical processes are substantiated.
A model is proposed for the formation of metallic phase when gaseous reducing agent is bubbled through multicomponent oxide melt. The model includes the following stages: the formation of bubbles when gas is injected in the melt; the reduction of metal at the surface of the bubbles and its concentration in droplet form at the rear of the bubble; motion of the bubble–droplet system in a direction determined by the ratio of the uplift forces on the bubble and the gravitational forces on the droplet; entrainment of the droplets to the surface; and coalescence of the droplets and their descent on reaching a size such that the gravitational forces exceed the sum of the hydrostatic collision forces and the surface tension forces. Equations are presented for estimating the size of the gas bubble and the droplet moving in oxide melt without decrease in size; the direction of motion of the bubble–droplet system; its rate of ascent or descent; and the conditions in which the bubble–droplet system breaks down. The factors responsible for separation of the bubble and the droplet are identified: the surface properties of the oxide melt and the metallic melts and their interphase characteristics. By adjusting these parameters, the formation of metallic phase at the bottom of the vessel may be regulated.