Electrochemical nitrate reduction to ammonia offers an attractive solution to environmental sustainability and clean energy production but suffers from the sluggish *NO hydrogenation with the spin–state transitions. Herein, we report that the manipulation of oxygen vacancies can contrive spin−polarized Fe1−Ti pairs on monolithic titanium electrode that exhibits an attractive NH3 yield rate of 272,000 μg h−1 mgFe−1 and a high NH3 Faradic efficiency of 95.2% at −0.4 V vs. RHE, far superior to the counterpart with spin−depressed Fe1−Ti pairs (51000 μg h–1 mgFe–1) and the mostly reported electrocatalysts. The unpaired spin electrons of Fe and Ti atoms can effectively interact with the key intermediates, facilitating the *NO hydrogenation. Coupling a flow−through electrolyzer with a membrane-based NH3 recovery unit, the simultaneous nitrate reduction and NH3 recovery was realized. This work offers a pioneering strategy for manipulating spin polarization of electrocatalysts within pair sites for nitrate wastewater treatment.
Electrochemical urea oxidation offers a sustainable avenue for H2 production and wastewater denitrification within the water-energy nexus; however, its wide application is limited by detrimental cyanate or nitrite production instead of innocuous N2. Herein we demonstrate that atomically isolated asymmetric Ni–O–Ti sites on Ti foam anode achieve a N2 selectivity of 99%, surpassing the connected symmetric Ni–O–Ni counterparts in documented Ni-based electrocatalysts with N2 selectivity below 55%, and also deliver a H2 evolution rate of 22.0 mL h–1 when coupled to a Pt counter cathode under 213 mA cm–2 at 1.40 VRHE. These asymmetric sites, featuring oxygenophilic Ti adjacent to Ni, favor interaction with the carbonyl over amino groups in urea, thus preventing premature resonant C⎓N bond breakage before intramolecular N–N coupling towards N2 evolution. A prototype device powered by a commercial Si photovoltaic cell is further developed for solar-powered on-site urine processing and decentralized H2 production.
Electrochemical hydrogenation (ECH) of unsaturated carbon-heteroatom bonds is essential for chemical transformations but is often limited by a barrier-intensive surface hydrogen transfer process. The interfacial hydrogen bond (HB) network offers a promising pathway for proton transfer but requires addressing the challenge of nondirectional proton shuttling in three-dimensional space. Here, we create hydrophilic CuO x islands on Cu foam (CF) and load electron-enriched Pd (Pd δ− ) single atoms as proton traps (Pd 1 -CuO x /CF) to guide a fast proton transfer along a modified HB network to enhance ECH efficiency. During ECH, hydrophilic CuO x islands dissociate H 2 O into protons and reconstruct the interfacial HB network for facile proton transfer, while the Pd δ− single atoms reorient H 2 O molecules to electrostatically attract and reduce protons to active hydrogen, enabling efficient substrate hydrogenation. With guided proton transfer, Pd 1 -CuO x /CF achieves 99% hydrogenation efficiency for C─Cl bonds, outperforming Pd 1 -CF (69%) and CuO x /CF (57%), and demonstrates high selectivity and Faradaic efficiency in hydrogenating C═O and C≡N bonds to produce valuable chemicals.
Electrochemical ammonia (NH 3 ) synthesis from nitrate reduction (NITRR) offers an appealing solution for addressing environmental concerns and the energy crisis. However, most of the developed electrocatalysts reduce NO 3− to NH 3 via a hydrogen (H*)-mediated reduction mechanism, which suffers from undesired H*-H* dimerization to H 2 , resulting in unsatisfactory NH 3 yields. Herein, we demonstrate that reversed I 1 Cu 4 single-atom sites, prepared by anchoring iodine single atoms on the Cu surface, realized superior NITRR with a superior ammonia yield rate of 4.36 mg h −1 cm −2 and a Faradaic efficiency of 98.5% under neutral conditions via a proton-coupled electron transfer (PCET) mechanism, far beyond those of traditional Cu sites (NH 3 yield rate of 0.082 mg h −1 cm −2 and Faradaic efficiency of 36.5%) and most of H*-mediated NITRR electrocatalysts. Theoretical calculations revealed that I single atoms can regulate the local electronic structures of adjacent Cu sites in favor of stronger O-end-bidentate NO 3− adsorption with dual electron transfer channels and suppress the H* formation from the H 2 O dissociation, thus switching the NITRR mechanism from H*-mediated reduction to PCET. By integrating the monolithic I 1 Cu 4 single-atom electrode into a flow-through device for continuous NITRR and in situ ammonia recovery, an industrial-level current density of 1 A cm −2 was achieved along with a NH 3 yield rate of 69.4 mg h −1 cm −2 . This study offers reversed single-atom sites for electrochemical ammonia synthesis with nitrate wastewater and sheds light on the importance of switching catalytic mechanisms in improving the performance of electrochemical reactions.