Experimental and numerical studies on a high head model Francis turbine were carried out over the entire range of turbine operation. A complete Hill diagram was constructed and pressure-time measurements were performed at several operating conditions over the entire range of power generation by installing pressure sensors in the rotating and stationary domains of the turbine. Unsteady numerical simulations were performed at five operating conditions using two turbulent models, shear stress transport (SST) k-ω and standard k-ε and two advection schemes, high resolution and second order upwind. There was a very small difference (0.85%) between the experimental and numerical hydraulic efficiencies at the best efficiency point (BEP); the maximum difference (14%) between the experimental and numerical efficiencies was found at lower discharge turbine operation. Investigation of both the numerical and experimental pressure-time signals showed that the complex interaction between the rotor and stator caused an output torque oscillation over a particular power generation range. The pressure oscillations that developed due to guide vanes and runner blades interaction propagate up to the trailing edge of the blades. Fourier analysis of the signals revealed the presence of a vortex rope in the draft tube during turbine operation away from the BEP.

The penetration of intermittent wind and solar power to the grid network above manageable limits disrupts electrical power grids. Consequently, hydraulic turbines synchronized to the grid experience total load rejection and are forced to shut down immediately. The turbine runner accelerates to runaway speeds in a few seconds, inducing high-amplitude, unsteady pressure loading on the blades. This sometimes results in a failure of the turbine components. Moreover, the unsteady pressure loading significantly affects the operating life of the turbine runner. Transient measurements were carried out on a scale model of a Francis turbine prototype (specific speed = 0.27) during an emergency shutdown with a transition into total load rejection. A detailed analysis of variables such as the head, discharge, pressure at different locations including the runner blades, shaft torque, and the guide vane angular movements are performed. The maximum amplitudes of the unsteady pressure fluctuations in the turbine were observed under a runaway condition. The amplitudes were 2.1 and 2.6 times that of the pressure loading at the best efficiency point in the vaneless space and runner, respectively. Such high-amplitude, unsteady pressure pulsations can affect the operating life of the turbine.