In this study, research was conducted to examine the performance of the lime pile application, a deep chemical stabilization method to improve the engineering characteristics of marine soil deposits. By using a laboratory-scale model, the marine soil sample was compacted into soil blocks in circular steel test tanks, with the installation of lime piles in them. An experimental program examined the effect of lime piles on physical and engineering properties of the soil in terms of curing periods and lime pile radial distances. Test results showed that clay fines, linear shrinkage, compressibility, and swelling pressure decreased, while permeability, preconsolidation pressure, and stiffness increased significantly with an increase in curing periods and within a close distance to the lime piles. Also, the electrical resistivity of the treated soils was examined to monitor the changes in their electrical properties. Finally, the correlation between the measured electrical resistivity and swell pressure values of the tested soils at different curing periods suggested that the electrical resistivity values can be used as a monitoring technique for deep chemical treatments of the subsurface soil.
Dampness is a major building challenge that poses a health risk by aiding the growth of mold and other related microorganisms in very humid areas. Thus, the correction of these post-effects results in high maintenance costs via energy consumption, due to the prolonged heating of damp rooms and post-treatment, especially during the winter. A survey of 2000 valid respondents living in apartment-style buildings was conducted and analyzed using SPSS software. In this study, the AutoDesk Computational Fluid Dynamics (ACFD) software was used to perform a simulation for building materials analysis, to evaluate them for suitability in high humidity areas and to select the best building orientation for adequate and natural ventilation. The analysis aimed to observe the indoor air conditions due to environmental air flow conditions. The relationships of the airflow conditions to the material properties were measured. The methodology involves a Failure Modes and Effects Analysis to determine the level and nature of the dampness sources. The Design-Expert Statistical-Software 10 confirmed the simulation results. The simulation revealed a lower percentage of relative humidity and temperature in Adobe walls than in brick walls.