A three phase cascaded multilevel inverter topology and a hybrid control technique are presented in this paper. The topology is derived from a proposed module of addition and subtraction of sources (MASS). An attempt is made to optimize the component count, viz., power switches count, gate drive count, capacitor count, diode count and source count. The operating modes of basic module and the proposed three phase topology are explained. The analysis is presented for both symmetrical and asymmetrical configurations. The fundamental frequency hybrid control technique, which is derived from Nearest Level Control (NLC) and Switching Frequency Optimal (SFO) algorithms, is presented. The power semiconductor switches in the topology are driven by gating signals generated with hybrid SFO-NLC technique. The necessary comparisons are done to show the enhanced features with the view of optimized component count and power quality. The simulation results are carried out by MATLAB/SIMULINK software tool under both steady state and dynamic conditions. Experimental results are presented to validate the simulation results.
8 March 2018 in International Journal of Circuit Theory and Applications
The huge untapped energy from ocean waves is one of the ideal solution for world energy crisis. This paper proposes a linear generator based direct power conversion plant model to generate the electrical energy from ocean waves. The linear generator output is of variable magnitude and variable frequency in nature. In this work, this variable output is converted to fixed DC voltage by using diode bridge rectifier and DC-link capacitor. The linear generator along with diode bridge and capacitor forms a wave power unit. These wave power units can be connected in series and parallel to meet the power ratings. A reliable multilevel inverter is fed from the wave power units to ensure uninterrupted tapping of power from this abundant renewable energy source. The reliable inverter operation is analyzed under open/short circuit faults in switches by reconfiguring the carrier waves of sine pulse width modulation (SPWM) during fault conditions. A fault detection algorithm using a single sensor at the output is also proposed to detect the faults in the switches of the proposed reliable inverter. The proposed plant model with linear generator and reliable inverter is simulated using ANSYS MAXWELL and MATLAB/SIMULINK. The plant model is tested using a programmable AC source for emulating the linear generator and developed prototype of diode bridge rectifier and reliable multilevel inverter.
7 March 2019 in Journal of Circuits, Systems and Computers
This paper proposes cascaded multilevel inverter topology that sustains open circuit faults in all switches. The basic unit of proposed circuit is designed with four unidirectional and two bidirectional switches to produce a five level output. It maintains the output voltage for an open circuit fault in any one of the bidirectional switch and the output falls to three levels for an open circuit fault in any one of the unidirectional switches. The proposed circuit is simulated using MATLAB/SIMULINK and a hardware prototype is developed to validate the theoretical and simulation claims.