A new method for studying the two-dimensional spreading properties and sealing characteristics of surfactant solution on oil surface was provided. The actual spreading situation of the C4-Br/oil systems in axisymmetric geometry was observed directly using HD camera for the first time and the results showed that the aqueous film expanded outwards in a circle with the guiding device as the center. Meanwhile, the relation between spreading radius and time was investigated and evaluated using the model for surface-tension-viscous regime. The root-mean-square deviation (RMSD) values obtained from the correlation for all of the systems we studied below 1.64, indicating a good agreement between the experimental and theoretical values. The results of sealing experiments showed that the aqueous film could absolutely seal the oil surface for 27–65 s and the sealing effect would be lost after 216–742 s for different systems. The stronger the volatility was, the shorter the sealing time was. Additionally, the volume percentage of oil vapor with film was always lower than that without film even when the evaporation was saturated. These findings were of great significance to guide the preparation of efficient AFFF.
Perfluorooctane sulfonate (PFOS) and its derivatives had been banned due to their potential environmental hazards, although they possessed excellent surface activity. An effective method to solve this problem was to shorten the fluorocarbon chain of these surfactants from C°H17 to C4F9. As previous studies had shown, zwitterionic surfactants possess higher surface activity but have lower toxicity compared to other types of surfactants. In view of this, a class of novel zwitterionic fluorocarbon surfactants (n-CFNA-Br) with perfluorobutyl moiety was synthesized in this work. Their structures were characterized by FTIR, 1H NMR, 13C NMR, 19F NMR and MS. The results showed that all synthesized n-CFNA-Br had almost the same minimum surface tension, but their critical micelle concentration (CMC) decreased with increasing length of hydrophobic carbon chain. In pure water, the surface tension at the CMC (γCMC) of the four n-CFNA-Br were about 20 mN/m, and the CMC values were 7.73 mmol/L for 1-CFNA-Br, 4.70 mmol/L for 2-CFNA-Br, 4.13 mmol/L for 3-CFNA-Br, and 3.36 mmol/L for 4-CFNA-Br, indicating high efficiency and effectiveness. In 0.1 mol/L NaCl, the CMC values reduced to less than half of the CMC values measured in the pure aqueous surfactant solution, while the surface tensions γCMC remained almost unchanged, indicating good salinity tolerance of the synthesized surfactants. The acidic surfactant solutions exhibited similar CMC values to the saline solutions, but the surface tension γCMC increased slightly to 25 mN/m. However, further investigation showed that the n-CFNA-Br surfactants exhibited poor surface activity in alkaline solution (0.1 mol/L NaOH). In the pH range of 6.6 to 10.4, white precipitates appeared in the surfactant solutions after some time, indicating that the n-CFNA-Br are not suitable for use in alkaline systems with pH greater than 6.6.