To prevent pesticides from exceeding maximum residue limits (MRLs) in crops during export and shipment, it is necessary to manage residue levels during the pre-harvest stages. Therefore, the Republic of Korea establishes pre-harvest residue limits (PHRLs) per crop and pesticide. This study was conducted to set PHRLs for penthiopyrad and tebufenpyrad in angelica leaves, where the exceedance rates of MRLs are expected to be high. The LOQ of the analytical method used was 0.01 mg/kg and it demonstrated good linearity, with a correlation coefficient of 0.999 or higher within the quantitation range of 0.005 to 0.5 mg/kg. The recovery and storage stability accuracy values were in the range of 94.5–111.1%, within the acceptable range (70–120%, RSD ≤ 20%). The matrix effect for both pesticides was in the medium-to-strong range, and it did not significantly impact the quantitative results as a matrix-matched calibration method was employed. Using the validated method, residue concentrations of penthiopyrad 20 (%) EC and tebufenpyrad 10 (%) EC were analyzed. Both pesticides exhibited a decreasing residue trend over time. In Fields 1–3 and their integrated results, the biological half-life was within 2.6–4.0 days for penthiopyrad and 3.0–4.2 days for tebufenpyrad. The minimum value of the regression coefficient in the dissipation curve regression equation was selected as the dissipation constant. The selected dissipation constants for penthiopyrad in Fields 1–3 and their integration were 0.1221, 0.2081, 0.2162, and 0.1960. For tebufenpyrad, the dissipation constants were 0.1451, 0.0960, 0.1725, and 0.1600, respectively. The dissipation constant was used to calculate PHRL per field. Following the principles of the PHRL proposal process, residue levels (%) on PHI dates relative to MRLs were calculated, and fields for proposing PHRLs were selected. For penthiopyrad, since the residue level (%) was less than 20%, the PHRL for Field 3 with the largest dissipation constant was proposed. For tebufenpyrad, as the residue level (%) exceeded 80%, the PHRL proposal could not established. It is deemed necessary to reassess the MRL and ‘guidelines for safe use’ for tebufenpyrad in angelica leaves.

Enhancements to the analytical method for the determination of tricyclazole in rice samples have been applied to monitor residues during unmanned aerial spraying. The acetonitrile extraction technique QuEChERS was improved by the incorporation of ethyl acetate and 0.1% formic acid, which significantly elevated the recovery rates. Furthermore, the purification process was refined by integrating both primary–secondary amine (PSA) and C18 in the dSPE method, achieving a substantial improvement in reducing matrix effects (MEs) and increasing recovery efficiency. The optimized method demonstrated an impressive % ME value at −3.1%, with a limit of quantitation (LOQ) established at 0.01 mg/kg, and recovery rates between 94.7 and 95.6% at 0.01, 0.1, and 2 mg/kg. Using two types of adjuvants (stickers) during multi-copter spraying markedly improved the initial tricyclazole deposition on rice panicles, with residue levels initially increasing from 0.35 mg/kg to between 0.68 and 1.60 mg/kg. Residues in hulled rice at harvest (10 days post-application) remained well below the maximum residue limit (MRL) of 0.7 mg/kg, ranging from 0.02 to 0.11 mg/kg, thus affirming the safety and efficacy of adjuvants in residue management.

Pencycuron is a fungicide whose maximum residue limit (MRL) in eggplant is either set at very low levels (0.02 mg/kg in European Union) or remains unestablished in many countries, necessitating stringent pesticide management. To enable timely interventions by farmers and regulators, pre-harvest residue limits (PHRLs) propose maximum allowable pesticide concentrations for each day during the pre-harvest period. An analytical method was developed to conduct residue determination trials, demonstrating that graphitized carbon black (GCB) effectively removes eggplant matrices during sample preparation. The LC-MS/MS method was established with a limit of quantification (LOQ) of 0.005 mg/kg, recovery rates ranging from 102.6% to 106.1% with relative standard deviation (RSD; 2.3–6.4%), and a matrix effect (%ME) of +8.1%. Residue analysis revealed a concentration of 0.045 mg/kg at 0 days after treatment (DAT), decreasing to 0.006 mg/kg at 14 DAT. The residue dynamics followed a first-order kinetic model, as confirmed by the F-test, with a rate constant of 0.1405. Therefore, the half-life was determined to be 4.9 d. Based on the MRL value of 0.02 mg/kg at 0 days before harvest (DBH), the PHRL was determined using both k and k_min, resulting in values of 0.04 mg/kg and 0.02 mg/kg at 5 days and 0.08 mg/kg and 0.03 mg/kg at 10 DBH, respectively. Using k_min yields more conservative results, which ensures food safety under conditions of slower degradation rates.

Rice straw is used as livestock feed and compost. Ferimzone and tricyclazole, common fungicides for rice blast control, can be found in high concentrations in rice straw after unmanned aerial vehicle (UAV) spraying, potentially affecting livestock and human health through pesticide residues. In this study, an optimized method for the analysis of the two fungicides in rice straw was developed using the improved QuEChERS method. After the optimization of water and solvent volume, extraction conditions including ethyl acetate (EtOAc), acetonitrile (MeCN), a mixed solvent, and MeCN containing 1% acetic acid were compared. Different salts, including unbuffered sodium chloride, citrate, and acetate buffer salts, were compared for partitioning. Among the preparation methods, the MeCN/EtOAc mixture with unbuffered salts showed the highest recovery rates (88.1–97.9%, RSD ≤ 5.1%). To address the severe matrix effect (%ME) of rice straw, which is characterized by low moisture content and cellulose-based complex matrices, samples were purified using 25 mg each of primary–secondary amine (PSA) and octadecylsilane (C₁₈), without pesticide loss. The developed method was validated with a limit of quantification (LOQ) of 0.005 mg/kg for target pesticides, and recovery rates at levels of 0.01, 0.1, and 2 mg/kg met the permissible range (82.3–98.9%, RSD ≤ 8.3%). The %ME ranged from −17.6% to −0.3%, indicating a negligible effect. This optimized method was subsequently applied to residue studies following multi-rotor spraying. Fungicides from all fields and treatment groups during harvest season did not exceed the maximum residue limits (MRLs) for livestock feed. This confirms that UAV spraying can be safely managed without causing excessive residues.

A robust analytical method was developed for the simultaneous detection of 504 pesticide multiresidues in various crops using ultra-high-performance liquid chromatography coupled with quadrupole time-of-flight mass spectrometry (UHPLC-QTOF). The method integrates both MS¹ and MS² levels through sequential window acquisition of all theoretical mass spectra (SWATH) analysis, allowing for accurate mass measurements and the construction of a spectral library to enhance pesticide residue identification. An evaluation of the method was carried out according to international standards, including the FAO guidelines and SANTE/11312/2021. Validation across five representative crops—potato, cabbage, mandarin, brown rice, and soybean—demonstrated exceptional sensitivity, with over 80% of the analytes detected at trace levels (≤2.5 μg/kg). Moreover, an impressive 96.8% to 98.8% of the compounds demonstrated LOQs of ≤10 μg/kg. Most compounds exhibited excellent linearity (r² ≥ 0.980) and satisfactory recovery rates at spiking levels of 0.01 and 0.1 mg/kg. Among 42 crop samples analyzed, pesticides were detected in 1 cabbage, 3 mandarin, and 6 rice samples, with a mass accuracy within ±5 ppm and a Fit score ≥ 70.8, confirming the method’s practical applicability and reliability. The detected residues ranged from 12.3 to 339.3 μg/kg, all below the established maximum residue limits (MRLs). This comprehensive approach offers an efficient, reliable, and scalable solution for pesticide multiresidue monitoring, supporting food safety programs and regulatory compliance.