Evidence of exoplanets with orbits that are misaligned with the spin of the host star may suggest that not all bound planets were born in the protoplanetary disk of their current planetary system. Observations have shown that free-floating Jupiter-mass objects can exceed the number of stars in our galaxy, implying that capture scenarios may not be so rare. To address this issue, we construct a three-dimensional simulation of a three-body scattering between a free-floating planet and a star accompanied by a Jupiter-mass bound planet. We distinguish between three different possible scattering outcomes, where the free-floating planet may get weakly captured after the brief interaction with the binary, remain unbound, or “kick-out” the bound planet and replace it. The simulation was performed for different masses of the free-floating planets and stars, as well as different impact parameters, inclination angles and approach velocities. The outcome statistics are used to construct an analytical approximation of the cross section for capturing a free-floating planet by fitting their dependence on the tested variables. The analytically approximated cross section is used to predict the capture rate for these kinds of objects, and to estimate that about 1% of all stars are expected to experience a temporary capture of a free-floating planet during their lifetime. Finally, we propose additional physical processes that may increase the capture statistics and whose contribution should be considered in future simulations in order to determine the fate of the temporarily captured planets.
1 April 2004 in Journal of the Optical Society of America A
Hartmann–Shack wave-front sensors produce a distorted grid of spots whose deviation from perfection is linear with the wave-front gradient. Usually, the centroid of each spot is calculated to provide that deviation, but it is also possible to perform the calculation by Fourier demodulation of the spot pattern [Opt. Commun. 215, 285, 2003]. We show that this demodulation can be performed directly on the grid, without reverting to Fourier transforms. Tracking the motion of each centroid individually is limited to well-defined spots with motions smaller than their pitch. In contrast, our method treats the image as a whole, is not limited to nonoverlapping or sharp spots, and allows large spot motions. By replicating the array of spots slightly beyond the edge of the aperture, we reduce the chance for boundary phase dislocations in the reconstruction of the wave front. The method is especially suited to very large arrays.
10 June 2011 in Journal of the Optical Society of America A
High-resolution retinal imaging requires dilating the pupil, and therefore exposing more aberrations that blur the image. We developed an image processing technique that takes advantage of the natural movement of the eye to average out some of the high-order aberrations and to oversample the retina. This method was implemented on a long sequence of retinal images of subjects with normal vision. We were able to resolve the structures of the size of single cells in the living human retina. The improvement of resolution is independent of the acquisition method, as long as the image is not warped during scanning. Consequently, even better results can be expected by implementing this technique on higher-resolution images.
Analysis of Hartmann–Shack wavefront sensors for the eye is traditionally performed by locating and centroiding the sensor spots. These centroids provide the gradient, which is integrated to yield the ocular aberration. Fourier methods can replace the centroid stage, and Fourier integration can replace the direct integration. The two—demodulation and integration—can be combined to directly retrieve the wavefront, all in the Fourier domain. Now we applied this full Fourier analysis to circular apertures and real images. We performed a comparison between it and previous methods of convolution, interpolation, and Fourier demodulation. We also compared it with a centroid method, which yields the Zernike coefficients of the wavefront. The best performance was achieved for ocular pupils with a small boundary slope or far from the boundary and acceptable results for images missing part of the pupil. The other Fourier analysis methods had much higher tolerance to noncentrosymmetric apertures.
Scintillation in measured wave fronts adds spurious dislocations and deformations to their reconstruction. The source of the problem is caustics formed by aberrations in intermediate planes. I propose to use intentional caustics to measure wave fronts under severe conditions such as low light level, fast scale variations, large aberrations, and discontinuities in the wave front. A simple realization is based on the Hartmann–Shack sensor, which samples the wave front with a lenslet array. Movement of the lenslets’ foci is linear with slope changes. Here the lenslets are effectively formed in an acousto-optic device: Two standing waves are launched perpendicularly to the light beam and to each other. At some distance down the beam, each wave creates a comb of caustics, and the two orthogonal combs add up to an array of caustic spots. The spatial frequency of the array is linear with the temporal frequency of the standing sound waves. A simple Fourier demodulation scheme supplies the two wave-front gradients.
Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.