Jiarui Cao

Ms. Jiarui Cao

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 November 2024 in Foods
Verified
Journal Article
Open access
PDF file
JCJiarui Cao
Jiarui Cao
MCMeinou Corstens
Meinou Corstens
Karin SchroenKarin Schroen
Karin Schroen
The protein transition motivates the use of plant proteins, but their application in food emulsions is challenging, especially when high concentrations of oil and salt are needed for formulation and sensory properties. In the present work, we connect the iso-electric point of two potato protein isolates (patatin-rich, POPI-200; protease inhibitor-rich, POPI-300) and a faba protein isolate (FPI) to the behavior in the bulk phase and at the interface, and relate this to the physical stability of 45 wt% oil-in-water (O/W) emulsions in the presence of NaCl at pH 4.0–7.0. In the absence of NaCl, a higher bulk viscosity was found at the iso-electric point (IEP), especially for the FPI. In the presence of NaCl, the viscosity of the POPI-200 solutions was highest, followed by POPI-300, and that of the FPI was lowest, irrespective of the pH. Both POPIs showed faster initial adsorption at the O/W interface in the absence of NaCl, and formed a more elastic layer compared to the FPI. For all proteins, salt addition leads to less elastic films. Interestingly, the interfaces were more elastic at a pH close to the IEP of the protein in the presence of NaCl. Both POPI-stabilized emulsions showed higher stability (smaller size and less oiling off) than the FPI-stabilized emulsions, which makes potato proteins relevant for food emulsion product formulation, even under high salt conditions.

8 September 2025 in LWT
Verified
Journal Article
Open access
JCJiarui Cao
Jiarui Cao
MCMeinou N. Corstens
Meinou N. Corstens
KSKarin Schroën
Karin Schroën

16 January 2026 in LWT
Verified
Journal Article
Open access
JCJiarui Cao
Jiarui Cao
MCMeinou N. Corstens
Meinou N. Corstens
KSKarin Schroën
Karin Schroën


26 June 2026 in Journal of Colloid and Interface Science
Verified
Journal Article
Open access
JCJiarui Cao
Jiarui Cao
TSTatiana Porto Santos
Tatiana Porto Santos
PCPatricio Cid del Prado Castillo
Patricio Cid del Prado Castillo
BDBoxin Deng
Boxin Deng
MCMeinou Corstens
Meinou Corstens
Karin SchroenKarin Schroen
Karin Schroen
Interfacial adsorption rate of emulsifiers governs droplet coalescence during emulsification. These fast dynamic processes remain poorly understood for plant proteins, especially under practical conditions such as heating. We hypothesize that moderate preheating (below denaturation temperature) on the potato protein (POPI) enhances adsorption through increased hydrophobic exposure, while excessive heating leads to aggregation that decreases interfacial film strength, with these mechanisms governing early-time droplet stability. The effect of protein concentration and preheating temperature (20-95 °C) on the short-time interfacial behavior of POPI was investigated. Protein adsorption at the oil-water interface and droplet re-coalescence were determined at millisecond timescales using two microfluidic devices: the Edge-based Droplet GEneration (EDGE) tensiometer and the coalescence cell. POPI (2 wt%) adsorbed rapidly at the oil-water interface (∼27 ms to decrease from the initial bare interfacial tension value). Preheating POPI at temperatures below its denaturation temperature (Td ∼ 65 °C) sped up initial adsorption. When preheating at 70 °C, protein initial adsorption slowed down due to aggregation that delayed diffusion. However, at 95 °C, adsorption increased again, possibly because of further exposure of hydrophobic residues that enhanced interfacial affinity. Despite changes in adsorption rate, heating generally increased droplet coalescence. This indicates that interfacial properties rather than adsorption rate alone, control early-time stability. Furthermore, increasing protein concentration compensated for heat-induced functionality loss. These results reveal how heat-induced protein changes govern its interfacial adsorption and stabilization at short timescales, providing new insights relevant to the design of stable (plant) protein-stabilized emulsions.