Epoxy resin composite matrices reinforced with carbon fibers are highly demanded by certain industries such as the aeronautics industry because of their exceptional mechanical properties. Unfortunately, the use of reinforcing carbon fibers makes these composite materials hard to recycle by conventional methods. Therefore, in this study, specific hydrothermal treatments have been employed to recover carbon fibers from the offcuts of composite parts from the aeronautics industry. The resin decomposition rates (DRs) achieved by different settings of the operating parameters, such as the use of alkaline catalysts (KOH, NaOH, or K2CO3), the application of mechanical stirring, the use of different reaction times, the solvent volume/composite mass ratio, the specific surface area (surface area/mass) of the composite pieces, and the operating temperature and pressure (subcritical or supercritical conditions), have been examined and assessed. Under the conditions that have been evaluated, resin decomposition rates nearly as high as 98% have been achieved, while the recycled fibers retained over 95% of their original tensile strength (TS).
Worldwide, carbon fiber (CF) demand has been rising over the last decade, which contrasts with the fact that up to 30–50% of composite materials in aircraft production are scrapped. This situation highlights the increasing need for recycling methods to reduce fabrication costs and global warming potential. Emerging technologies focus on recovering long CFs, as they represent the most valuable form but are also the most difficult to reclaim using conventional recycling methods. Hydrothermal treatments offer a promising alternative to valorize this waste by decomposing the polymer matrix under subcritical and supercritical conditions without significantly damaging the fibers. Water, isopropanol, and mixtures of water/isopropanol or water/acetone were tested as solvents, with and without the addition of zinc chloride (ZnCl2) as a homogeneous catalyst. The influence of temperature, pressure, and solvent composition on resin degradation was evaluated. In this work, degradation rates of up to 92% were achieved at 415 °C, 233 bar, 120 min, 5 wt.% IPA, and ZnCl2 0.1 M. It should be noted that ZnCl2 caused reactor corrosion. Furthermore, the recovered fibers retained their morphology, including the sizing layer, and showed mechanical properties similar to the original material, while a small H2-rich gaseous fraction was generated as a byproduct of the hydrothermal degradation. Using water–isopropanol solutions resulted in the reactor being significantly cleaner than when using water alone, which can be advantageous for future scale-up and for reducing maintenance requirements. These results confirm the potential of hydrothermal processing as an efficient and selective method for the recycling and valorization of carbon-fiber-reinforced composites from the aeronautical industry.
Degradable polymers are essential in tissue engineering due to their capacity to mimic the extracellular matrix and promote regeneration. To be functional, they require interconnected porous structures that allow for nutrient exchange and cell migration. Although methods exist to optimize porosity, many compromise biocompatibility because pore-forming substances are used. In this context, hydrothermal pretreatment emerges as a promising technique to simultaneously improve both the porosity and mechanical properties of polymers without using potentially toxic reagents. This study proposes a novel route that combines hydrothermal pretreatment with supercritical CO2 foaming, evaluating whether the structures obtained present better characteristics for biomedical applications compared to those obtained using supercritical CO2 foaming alone. A screening of this novel route has been tested on individual polymers (PCL, PLA, PLGA, PVA, PBS, chitosan) and various binary combinations (PCL-PBS, chitosan-PBS, PVA-PBS, PLGA-PEDOT: PSS). The resulting materials were characterized using electron microscopy to analyze pore diameter and distribution, as well as structural stability and homogeneity. For the individual polymers, the hydrothermal pretreatment clearly improved the results obtained. However, most polymer combinations showed drawbacks such as mass losses, heterogeneity, or unsatisfactory pore formation. This research highlights the potential of hydrothermal pretreatment to optimize scaffolds, which is crucial for viability in biomedical applications.