We present a bulk nanocrystalline copper alloy that can operate at near-melting temperatures with minimal coarsening and creep deformation. The thermal stability of the Cu-3Ta-0.5Li atomic % (at %) alloy is attributed to coherent, ordered L1 2 Cu 3 Li precipitates surrounded by a tantalum-rich atomic bilayer phase boundary complexion. Adding 0.5 at % lithium to the immiscible Cu-Ta system changes the morphology of the nanoscale precipitates from spherical to cuboidal while simultaneously tailoring the phase boundary. The resultant complexion-stabilized nanoscale precipitates provide excellent thermal stability, strength, and creep resistance. The underlying alloy design principles may guide the development of next-generation copper alloys for high-temperature applications such as heat exchangers.
Thermo-mechanically stabilized nanocrystalline (NC) alloys are increasingly valued for their enhanced mechanical strength and high-temperature stability, achieved through thermodynamic and kinetic stabilization methods. However, their fine-grained structure also increases susceptibility to internal oxidation due to higher atomic diffusivity associated with a greater volume fraction of grain boundaries (GBs). By incorporating solutes that form protective oxides, or the so-called thermally growing oxides (TGO), this vulnerability can be mitigated. The TGO scale acts as a diffusion barrier for oxygen that slows down the oxidation kinetics and prevents internal oxidation that impairs the structural integrity of the metal. This review examines advancements in oxidation-resistant NC alloys, focusing on the interplay between grain size and alloy chemistry. We explore how grain refinement influences diffusion coefficients, particularly the enhanced GB diffusion of Ni and Cr in Ni-Cr-based alloys, which improves oxidation resistance in NC variants like Ni-Cr and Cu-Cr compared to coarse-grained counterparts. We also analyze the role of third elements as oxygen scavengers and the impact of reactive elements such as Hf, Zr, and Y in NiAl alloys, which can slow down diffusion through early establishment of protective TGO layers and enhance oxidation resistance. The concomitant effect of grain size refinement, modifications in alloy stoichiometry, and enhanced atomic diffusion is shown to manifest via drastic reductions in oxidative mass gain, and visualization of the stable, protective oxide scales is delivered through characterization techniques such as TEM, SEM, and EDS. A brief overview is provided regarding stress effects and the role of induced stress in driving oxide scale spallation, which can negatively impact oxidation kinetics. Lastly, we propose future research directions aimed at developing micro-structurally stable NC alloys through multi-solute strategies and surface modification techniques, targeting robust materials for high-stress applications with improved oxidation resistance.
31 December 2014 in Materials Performance and Characterization
The low cycle fatigue behavior of AA2219-T87 was studied at ambient temperature using fully reversed total strain controlled fatigue tests in longitudinal and transverse orientations. Tension-compression cyclic tests were carried out under total strain amplitude control with strain ratio Rε = −1 and at a frequency of 0.5 Hz. The total strain amplitude was varied from ±0.4 to ±1.5 %. The low cycle fatigue results were analyzed to determine the cyclic stress strain curves. The cyclic strain hardening parameters were evaluated from the cyclic stress–strain curves. Important fatigue parameters namely fatigue ductility coefficient, fatigue ductility exponent, and fatigue strength coefficient were evaluated. The material exhibited cyclic strain softening in both longitudinal and transverse directions. Analysis of the experimental results showed that the stress–strain hysteresis loops exhibited inflections in the first few cycles and the plastic strain amplitude versus fatigue-life plots exhibited bi-linear relationship. The geometry of hysteresis loops and the occurrence of Masing behavior are analyzed and found that the alloy in peak aged condition exhibited tendency towards Masing behavior.