Low performance is considered one of the main drawbacks of laser powder bed fusion (LPBF) technology. In the present work, the effect of the AlSi10Mg powder layer thickness on the laser melting process was investigated to improve the LPBF building rate. A high-fidelity simulation of the melt pool formation was performed for different thicknesses of the powder bed using the Kintech Simulation Software for Additive Manufacturing (KiSSAM, version cd8e01d) developed by the authors. The powder bed after the recoating operation was obtained by the discrete element method. The laser energy deposition on the powder particles and the substrate was simulated by ray tracing. For the validation of the model, an experimental analysis of single tracks was performed on two types of substrates. The first substrate was manufactured directly with LPBF technology, while the second was cast. The simulation was carried out for various combinations of process parameters, predominantly with a high energy input, which provided a sufficient remelting depth. The calculations revealed the unstable keyhole mode appearance associated with the low absorptivity of the aluminum alloy at a scanning speed of 300 mm/s for all levels of the laser power (325–375 W). The results allowed formulating the criteria for the lack of fusion emerging during LPBF with an increased layer thickness. This work is expected to provide a scientific basis for the analysis of the maximum layer thickness via simulation to increase the performance of the technology.

A thin-walled product made of AZ31 magnesium alloy was successfully fabricated using wire-feed electron-beam additive manufacturing. The microstructure of the initial wire, used as a precursor, comprises a α-Mg(Al, Zn) solid solution and a minor amount of the Al₈Mn₅ intermetallic phase. The microstructure of the as-printed AZ31 alloy exhibits a three-phase structure: α-Mg(Al, Zn), Al₈Mn₅, and β-Mg₁₇Al₁₂. It was proposed that the secondary β-phase was formed via a primary solidification process upon the cooling of the welded layers. The texture effect was evident in the direction, corresponding to the printing direction, while other crystallographic orientations demonstrated near-equal pole densities as the XRD lines. The yield strength for the as-printed alloy was found to be 86 MPa; the tensile strength reached 240 MPa; and the relative elongation was 21.5%. For the first time, the corrosion resistance of an EBAM-fabricated AZ31 alloy was studied. It was revealed that the corrosion current density in the referenced as-cast and as-printed alloys was below 2·10⁻⁴ A/cm².

Over the last decade, laser powder bed fusion (LPBF) received increased attention as a method of producing complex-shaped products from various materials. Recent results indicate the potential of this technology for the production of intermetallic NiTi alloys with shape memory. Several studies have demonstrated a strong influence of the LPBF process conditions on the resulting material properties, i.e., the martensitic phase transformation temperatures, reversible/irreversible strain after cyclic loading, phase composition, chemical composition, etc. However, the mechanisms of functional properties altering during LPBF consolidation remain unexplored in the present state-of-the-art. This study aims to advance the knowledge about tailoring material properties of NiTi under laser influence. In this work, thin-walled samples were manufactured from pre-alloyed NiTi powder via LPBF in a wide window of laser power and scanning speed, excluding hatch spacing by employing a single track-based scanning strategy to reveal the pure effect of the laser’s influence. NiTi samples were characterized by various methods such as differential scanning calorimetry, X-ray diffraction, and mechanical tests. Established relationships between NiTi properties and the LPBF process conditions provide the basis for the development of NiTi production protocols with controlled functional properties.