Energy saving within shipping is gaining more attention due to environmental awareness, financial incentives, and, most importantly, new regional and international rules, which limit the acceptable emission from the ships considerably. One of the measures is installation of energy saving devices (ESD). One type of such a device, known as pre-swirl stator (PSS), consists of a number (usually 3 to 5) of fins, which are mounted right in front of the propeller. By modifying the inflow and swirl into the propeller, the fins of a PSS have the possibility to increase the total propulsion efficiency. However, at the same time, they may introduce additional resistance either due to changes in pressure distribution over the aft ship or due to its own resistance of fins. In this paper, the authors present experimental and numerical investigation of a PSS for a chemical tanker. Numerical analysis of the vessel with and without PSS is performed in the model and full scale. Model testing is performed with and without PSS to verify the power savings predicted numerically. Among other quantities, 3D wake field behind the hull is densely measured at different planes, starting from the PSS plane to the rudder stock plane. 3D wake measurements are also conducted with a running propeller. The measurements show considerable improvement in the performance of the vessel fitted with PSS. On the numerical side, analyses show that scale effect plays an important role in the ESD performance. Investigation of the scale effect on the vessel equipped with an ESD provides new insight for the community, which is investing more into the development of energy saving devices, and it offers valuable information for the elaboration of scaling procedures for such vessels.
This paper summarises the main findings from the full-scale Computational Fluid Dynamics (CFD) analyses conducted at SINTEF Ocean on the case of MV REGAL, which is one of the benchmark vessels studied in the ongoing joint industry project JoRes. The numerical approach is described in detail, and comparative results are presented regarding the propeller open water characteristics, ship towing resistance, and ship self-propulsion performance. The focus of numerical investigations is on the assessment of the existing simulation best practises applied to a ship-scale case in a blind simulation exercise and the performance thereof with different turbulence modelling methods. The results are compared directly with full-scale performance predictions based on model tests conducted at SINTEF Ocean and sea trials data obtained in the JoRes project.
In the present work, a generic ducted azimuth propulsor, which are frequently installed on a wide range of vessels, is subject to numerical investigation with the primary focus on performance deterioration and dynamic loads arising from the influence of oblique inflow and the presence of free surface. An unsteady Reynolds-Averaged Navier-Stokes (RANS) method with the interface Sliding Mesh technique is employed to resolve interaction between the propulsor components. The VOF formulation is used to resolve the presence of free surface. Numerical simulations are performed, separately, in single-phase fluid to address the influence of oblique inflow on the characteristics of a propulsor operating in free-sailing, trawling and bollard conditions, and in multi-phase flow to address the influence of propulsor submergence. Detailed comparisons with experimental data are presented for the case of a propulsor in oblique flow conditions, including integral propulsor characteristics, loads on propulsor components and single blade loads. The results of the study illustrate the differences in propulsor performance at positive and negative heading angles, reveal the frequencies of dynamic load peaks, and provide quantification of thrust losses due to the effect of a free surface without waves. The mechanisms of ventilation inception found at different propulsor loading conditions are discussed.
This paper summaries the main findings from the full-scale CFD analyses conducted at SINTEF Ocean on the case of MV REGAL, which is one of the benchmark vessels studied in the ongoing joint industry project JoRes. The numerical approach is described in detail, and comparative results are presented regarding the propeller open water characteristics, ship towing resistance, and ship self-propulsion performance. The focus of numerical investigations is on the assessment of the existing simulation best practices applied to a ship scale case in a blind simulation exercise, and performance of thereof with different turbulence modelling methods. The results are compared directly with full-scale performance predictions based on model tests conducted at SINTEF Ocean and sea trails data obtained in the JoRes project.