In this work, biopolymer chitosan and natural clay were used to obtain composite materials. The overall aim of this study was to improve the properties (porosity, thermal stability and density) of pure chitosan beads by the addition of clay and to obtain a chitosan-based composite material for the adsorption of heavy metals from an aqueous solution, using Mongolian resources, and to study the adsorption mechanism. The natural clay was pre-treated with acid and heat to remove the impurities. The chitosan and pre-treated clay were mixed in different ratios (8:1, 8:2 and 8:3) for chemical processing to obtain a composite bead for the adsorption of chromium ions. The adsorption of Cr(III) and Cr(VI) was studied as a function of the solution pH, time, temperature, initial concentration of the chromium solution and mass of the composite bead. It was found that the composite bead obtained from the mixture of chitosan and treated clay with a mass ratio of 8:1 and 8:2 had the highest adsorption capacity (23.5 and 17.31 mg·g−1) for Cr(III) and Cr(VI), respectively, in the optimum conditions. The properties of the composite materials, prepared by mixing chitosan and clay with a ratio of 8:1 and 8:2, were investigated using XRD, SEM–EDS, BET and TG analysis. The adsorption mechanism was discussed based on the XPS analysis results. It was confirmed that the chromium ions were adsorbed in their original form, such as Cr(III) and Cr(VI), without undergoing oxidation or reduction reactions. Furthermore, Cr(III) and Cr(VI) were associated with the hydroxyl and amino groups of the composite beads during adsorption. The kinetic, thermodynamic and isothermal analysis of the adsorption process revealed that the interaction between the chitosan/clay composite bead and Cr(III) and Cr(VI) ions can be considered as a second-order endothermic reaction, as such the adsorption can be assessed using the Langmuir isotherm model. It was concluded that the composite bead could be used as an adsorbent for the removal of chromium ions.
This study investigates the simultaneous adsorption of Pb(II), Cu(II), Cd(II), and Zn(II) ions from aqueous solutions using Urtica dioica leaves (UDLs) modified with sulfuric acid, followed by heat treatment to enhance adsorptive properties. The heat treatment significantly increased the adsorbent’s specific surface area to 451.93 m2·g−1. Batch adsorption experiments were performed to determine the influence of the contact time, pH of the aqueous solution, adsorbent dosage, temperature, and initial metal concentration on the adsorption efficiency. The material (modified UDLs) was characterized using X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR), scanning electron microscope (SEM), and X-ray photoelectron spectroscopy (XPS). Maximum removal efficiencies were determined as 99.2%, 96.4%, 88.7%, and 83.6% for Pb(II), Cu(II), Cd(II), and Zn(II) ions, respectively. Adsorption isotherms and kinetics revealed that the process follows the Langmuir equation and pseudo-second-order models, indicating monolayer adsorption and chemisorption mechanisms. Furthermore, thermodynamic analysis indicated that the adsorption processes are spontaneous and endothermic in nature. The influence of competing ions on the adsorption of multiple heavy metals was also discussed. The results suggest that sulfuric acid and heat-treated Urtica dioica leaves can offer a promising, low-cost, and eco-friendly adsorbent for removing heavy metal ions from contaminated water.