Low-carbon buildings and construction products can play a key role in creating a low-carbon society. Cross-laminated timber (CLT) is proposed as a prime example of innovative building products, revolutionising the use of timber in multi-storey construction. Therefore, an understanding of the synergy between structural engineering design solutions and climate impact of CLT is essential. In this study, the carbon footprint of a CLT multi-storey building is analysed in a life cycle perspective and strategies to optimise this are explored through a synergy approach, which integrates knowledge from optimised CLT utilisation, connections in CLT assemblies, risk management in building service-life and life cycle analysis. The study is based on emerging results in a multi-disciplinary research project to improve the competitiveness of CLT-based building systems through optimised structural engineering design and reduced climate impact. The impacts associated with material production, construction, service-life and end-of-life stages are analysed using a process-based life cycle analysis approach. The consequences of CLT panels and connection configurations are explored in the production and construction stages, the implications of plausible replacement scenarios are analysed during the service-life stage, and in the end-of-life stage the impacts of connection configuration for post-use material recovery and carbon footprint are analysed. The analyses show that a reduction of up to 43% in the life cycle carbon footprint can be achieved when employing the synergy approach. This study demonstrates the significance of the synergy between structural engineering design solutions and carbon footprint in CLT buildings.

In this study, static coefficients of friction for laminated veneer lumber on steel surfaces were determined experimentally. The focus was on the frictional behaviors at different pressure levels, which were studied in combination with other influencing parameters: fiber orientation, moisture content, and surface roughness. Coefficients of friction were obtained as 0.10–0.30 for a smooth steel surface and as high as 0.80 for a rough steel surface. Pressure influenced the measured coefficients of friction, and lower normal pressures yielded higher coefficients. The influence of fiber angle was observed to be moderate, although clearly detectable, thereby resulting in a higher coefficient of friction when sliding perpendicular rather than parallel to the grain. Moist specimens contained higher coefficients of friction than oven-dry specimens. The results provide realistic values for practical applications, particularly for use as input parameters of numerical simulations where the role of friction is often wrongfully considered.

The aim of the experimental study presented herein is the assessment and quantification of the behavior of individual dowels in multi-dowel connections loaded by a bending moment. For this purpose, double-shear, steel-to-timber connections with nine steel dowels arranged in different patterns and with different dowel diameters were tested in four-point bending. In order to achieve a ductile behavior with up to 7° relative rotation, the connections were partly reinforced with self-tapping screws. The reinforcement did not influence the global load–deformation behavior, neither for dowel diameters of 12 mm nor for 20 mm, as long as cracking was not decisive. The deformation of the individual dowels was studied by means of a non-contact deformation measurement system. Thus, the crushing deformation, that is, the deformation at the steel plate, and the bending deformation of the dowels could be quantified. In the case of 12 mm dowels, the bending deformation was larger than the crushing deformation, while it was smaller in the case of 20 mm dowels. Moreover, dowels loaded parallel to the grain showed larger bending deformations than dowels loaded perpendicular to the grain. This indicates that the loading of the individual dowels in the connection differs depending on their location