This paper presents for the first time a novel method of depositing plasmonic Bi nanoparticles on BiOCl nanosheets (Bi/BiOCl) via insitu photoelectroreduction, and Bi/BiOCl as the photocathode enabled solar water splitting in a TiO2–Bi/BiOCl photoelectrochemical (PEC) system. It is one of the challenges to understand the relationship between the PEC performance and the composite ratio of Bi/BiOCl, and the density functional theory calculation results show that charges obviously transfer from the Bi cluster to the BiOCl (001) surface. The structure of Bi/BiOCl photocathode has been successfully optimized, according to the current–potential curves and charge injection efficiency. The highly enhanced PEC activity could be attributed to the dual roles of Bi nanoparticles in enhancing the charge transfer and surface plasmon resonance (SPR) effect. More importantly, the optimal Bi/BiOCl photocathode achieved a solar hydrogen evolution rate of 2.4 µmol h−1 under full spectrum illumination (100 mW cm−2).
Two novel phenothiazine 5,5-dioxide (PDO) core building block-based hole transport materials (HTMs), termed PDO1 and PDO2, were designed and synthesized. The introduction of a sulfuryl group in a core unit can deeply influence the energy levels and charge carrier mobilities of relative HTMs. The combined suitable energy level alignment, higher hole mobility and conductivity, as well as highly efficient hole transfer of PDO2 enable the perovskite solar cell (PSC) to achieve an impressive power conversion efficiency (PCE) of 20.2% and good stability when aged under ambient conditions. These results demonstrate the potential versatility of the PDO building block for further development of cost-effective and highly efficient HTMs for PSCs.
The magnetic and electronic structures of LaMn3Cr4O12 are investigated using the full-potential linearized augmented plane wave method within both the generalized gradient approximation (GGA) and GGA + U (electronic correlation) methods. The calculated results indicate that LaMn3Cr4O12 is an antiferromagnetic insulator. The magnetic ordering is demonstrated to be G-type within both Mn-site and Cr-site spins. However, there is no obvious magnetic coupling between Mn-site and Cr-site sublattices, which is verified by the separate distribution of their corresponding partial density of states. Moreover, the magnetic coupling constants of JCr-Cr and JMn-Mn are predicted to be − 5.0 (− 2.8) and − 0.83 (− 0.63) meV within GGA (GGA + U), respectively, consistent with the experimentally observed two independent Néel temperatures (TN1 and TN2). The calculated densities of states reveal the experimentally reported charge formula of LaMn3+3Cr3+4O12.
29 November 2010 in Journal of Computational Chemistry
The total magnetic moment of the quadruple perovskite CaCu 3 Fe 2 Nb 2 O 12 is significantly reduced owing to the B-site antisite defects. They not only introduce the Fe(↓)–O–Fe Nb (↑) antiferromagnetic arrangement, but also induce antiparallel Cu spins in the totally disordered CaCu 3 Fe 2 Nb 2 O 12 .