Electrodeposition of some metals at room temperatures have been restricted in aqueous solutions to those that present a standard potential less negative than that of water reduction. Some of these metals could be deposited but with economic expense using either organic solvents or using more drastic conditions as molten salts. In this work we select to study the cobalt-samarium electrodeposition process possibilities, due to that upon depending the ratio between the metals this alloy could derive to potentially hard magnetic material. The interest at first is focused into the study of the deposition process of each metal partner and the corresponding joint process using as solvent the eutectic mixture 1 chlorine chloride: 2 urea.
This study analyzes the acute toxicity of Zn2+, Cd2+, and Cu2+ on water fleas. The hatching rate of D. magna ephippia was monitored under the influence of the pollutant at concentrations of 0.1 mg/L, 0.2 mg/L, 0.3 mg/L, 0.4 mg/L, 0.5 mg/L, and 1.0 mg/L over an exposure period of 42 h−67 h. The mortality rate of newborns was determined comparing with the control sample at 12 h, 24 h, and 48 h, as well as with the lethal concentration 50% (LC50). The results showed that Zn2+ appears to be less toxic to D. magna compared to Cd2+ and Cu2+, even at high concentrations, suggesting a greater tolerance of the ephippia to this metal. Newborn mortality increased significantly with higher concentrations and longer exposure times, with Cd2+ causing mortality rates of up to 100% after 48 h. In contrast, Zn2+ exhibited lower toxicity, although mortality increased with high concentrations and extended exposure periods.
30 July 2022 in International Journal of Environmental Science and Technology
The radon level was assessed in houses from two rural areas localized in Northeastern Romania. Long-term measurements were performed for a period of four months using a digital radon detector, model Corentium Home, AirThings 222. In addition, for every environment included in the study, investigations concerning the building materials, the floor type, the building year and the heating system were made. Accordingly, Spearman’s correlation coefficients of the study variables were calculated. The World Health Organization recommends an upper threshold of 100 Bq/m3 as a national reference level. For both studied areas, we calculated a mean indoor radon level of more than 100 Bq/m3, but in the Tomesti-Osoi area were recorded values of over 100, respectively 300 Bq/m3 in significantly more households. Indoor exposure to radon of people in the investigated houses was found in 75 and 35.3% of the cases, respectively, above the level accepted by international recommendations, with a moderate correlation between mean radon levels and the features of the residential buildings.