The aim was to compare the effect of different endodontic surgical treatments on the stress distributions in dentin of a simulated first mandibular molar tooth using the finite element analysis method. Three surgical endodontic procedures (apical resection, root amputation, and hemisection) were simulated in a first mandibular molar. Biodentine or mineral-trioxide-aggregate was used to repair the surgery site in apical resection and root amputation models; the remaining root canal spaces were filled with gutta-percha. Access cavities were restored using resin composite. In hemisection model, root canal was filled with gutta-percha, and coronal restoration was finished with a monolithic zirconia crown. A sound tooth model was created as a control model. An oblique force of 300 N angled at 45° to the occlusal plane was simulated. Maximum von Mises stresses were evaluated in dentin near the surgery regions and the entire tooth. Apical resection/Biodentine and apical resection/mineral-trioxide-aggregate models generated maximum von Mises stresses of 39.001 MPa and 39.106 MPa, respectively. The recorded maximum von Mises stresses in root amputation models were 66.491 MPa for root amputation/Biodentine and 73.063 MPa for root amputation/mineral-trioxide-aggregate models. The highest maximum von Mises stress value among all models was observed in the hemisection model, measuring 138.87 MPa. Hemisection induced the highest von Mises stresses in dentin, followed by root amputation and apical resection. In apical resection, Biodentine and mineral-trioxide-aggregate did not show a significant difference in stress distribution. Biodentine in root amputation may lead to lower stresses compared to mineral-trioxide-aggregate.
3 March 2022 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
In crane systems, lifting, carrying and lowering the load from one place have different dynamic effects on the system. One of these dynamic effects is the moving load problem caused by the movement of the load on the crane system. With the increasing technology in recent years, production speeds have increased. For this reason, it has made the requirements for fast-running cranes mandatory for the transportation and loading of products. Therefore, it is important to know the dynamic effects of the moving load in fast working conditions. In this experimental study, the dynamic effects occurring on the crane beams with different loads and different working speeds during the transportation of the load on the crane are analysed. Here, there are multiple cars on the crane, and these cars are designed in different numbers on the crane and can be operated at different speeds. Under these conditions, the dynamic effects that have arisen have been tested. Also, vibration measurements were carried out at different points on the bridges. And then, these parameters obtained were used in two different proposed neural network types to predict the vibrations that occur on the crane system. Simulation results show that two approaches suggested that a radial basis neural network type can be used as an adaptive predictor for such systems in the experimental applications.