The data included in this study was calculated based on data provided by the national project registry provided by the Colombian government. The data forecasts the evolution of the power generation capacity registered in non-conventional renewable energy source projects in three scenarios of implementation of the power generation capacity registered in the projects. Results can be used to benchmark non-conventional renewable energy sources in Colombia, interpret the effectiveness of renewable policies, and monitor the evolution of non-conventional renewable-based power generation. The data presented in the article relates to the research study: A look to the electricity generation from non-conventional renewable energy sources in Colombia [1].

The data presented in this article was used to assess and compare the most important methods used to estimate the efficiency during the operation of induction motors at different loads and power supply conditions. The experiment was developed in a test bench including a three-phase induction motor of 1.1 kW (De Lorenzo DL 1021). In addition, an adjustable voltage source, a variable-frequency drive, a resistor, and a magnetic powder brake control unit to regulate the load were used during the experiments. A power quality and energy analyzer (Fluke 435 series 6) was used to measure the electric variables during the experiments. Moreover, for the mechanical measures, the sensors of the brake control unit (De Lorenzo DL 1054TT) and a magnetic powder brake (De Lorenzo DL 1019P) were used. In total, 11 load factors were measured at different operation conditions, including balanced sinusoidal voltage, balanced harmonic voltage, unbalanced sinusoidal voltage and unbalanced harmonic voltage. A total of 10 measures were taken for each load factor at each operation condition. The data presented in this paper can be useful in the development and evaluation of new efficiency estimation methods for induction motors, considering different operation conditions and load factors. Moreover, it can serve to assess the impact of the energy quality on the efficiency of induction motors. The data is related to the manuscript "Assessment of the energy efficiency estimation methods on induction motors considering real-time monitoring" [1].

This paper presents an integrative approach to the design for assembly (DfA) methodologies, adapting these to the particularities of the elevation industry. A friendly design tool in form of software has been developed implementing the proposed approach and methodology. A study case for an elevator counterweight design has been presented to show and test the advantages of the new approach and developed tool. Improvements of approximately 7.9 percentage points in the assembly effort of the elevator counterweight have been obtained following the proposed approach.