Launching of underwater projectile from submarine is carried out by gas-steam ejection dynamic system. Specific velocity of projectile at water exit is essential for its successful launch. The velocity of projectile depends upon the projectile dimensions, mass and water depth which govern the pressure requirements for gas-steam ejection dynamic system. To investigate the pressure required to launch the projectile under various conditions, a two-dimensional, axisymmetric numerical model was established. The numerical simulations were performed using ANSYS Fluent software. Dynamic mesh method was applied to track the motion of projectile combined with a User Defined Function (UDF) to compute the forces exerted on the body of the projectile. To achieve specific exit velocity of projectile for number of cases by varying vehicle mass, nose shape, and water depth simulations were performed and corresponding pressure requirements for each case was determined. Results shows the nonlinearity in pressure requirements with changing different parameters to achieve same exit velocity. In addition, bubble cavity formation in water is analyzed.
A direct numerical simulation of a spatially developing turbulent boundary layer over a divergent and convergent superhydrophobic surface (SHS) was performed over the range 800 < Reθ < 1200. The surface patterns were aligned along the streamwise direction. The SHS was modeled as a pattern of free-slip and no-slip surfaces. The gas fraction of the divergent and convergent SHS was the same as that for the straight SHS for a given slip area. The divergent and convergent SHS gave 21% more drag reduction than the straight SHS. Although the maximum value of the streamwise slip velocity was larger over the divergent and convergent SHS, the average slip velocity (Uslip/U∞) was larger over the straight SHS. The greater drag reduction was attributed to the manipulation of the secondary flow in the y–z plane and the changes in the turbulence structure. The streamwise vortices generated by the secondary flow over the divergent and convergent SHS were diminished which reduced drag relative to the flow over the straight SHS. The ejection and sweep motions were weak, and the vortical structure was attenuated near the wall over the divergent and convergent SHS. The skin friction contributions were explored using the velocity–vorticity correlation. The vortex stretching contribution dominated the skin friction budget. The reduced skin friction over the divergent and convergent SHS resulted mainly from reduced vortex stretching.