A new color‐gradient lattice Boltzmann model is developed to simulate spontaneous imbibition in a porous media micromodel, which needs only two‐dimensional computational cost but considers essential three‐dimensional effects. A modified periodic boundary condition is introduced to deal with inlet and outlet boundaries with great ease and effectiveness. This model is first validated against analytical solutions and micromodel experiment. It is then used to study the spontaneous imbibition process in a homogeneous micromodel for varying viscosity ratios and contact angles. Depending on the viscosity ratio (λ) of wetting to nonwetting fluids, three different imbibition patterns are observed, namely unstable displacement (UD), stable displacement (SD), and crossover from UD to SD, which occur at , , and , respectively. When the crossover occurs, the wetting fluid saturation at breakthrough increases between two plateaus corresponding to UD and SD, respectively. Consistent with theoretical predictions from a single capillary, the wetting fluid saturation versus time follows the relation of for , and for . Due to the increased capillary valve resistance, increasing wetting phase contact angle is found to promote the flow instability, resulting in the development of preferential flow paths and thus some nonwetting fluid trapped in the flow direction. In addition, it is theoretically and numerically demonstrated that the effect of contact angle cannot be properly described by the theoretical equations derived from a single capillary because of the presence of capillary valve effect, which can be suppressed by decreasing contact angle or micromodel depth.
1 October 2016 in Journal of Petroleum Science and Engineering
In the oil development process, an immiscible third-phase slug can be injected to the formation temporarily to assist the water flooding, resulting in a three-phase flow underground. In this work, we study slug-assisted water flooding at the pore scale using the three-phase pseudopotential lattice Boltzmann model. We first briefly describe the three-phase pseudopotential model and propose a concise scheme to set the contact angles of the Janus droplet on the solid wall. Then, we simulate the slug-assisted water flooding process in different porous media structures, i.e., a single pore-throat channel, parallel throats, and a heterogeneous porous medium. The simulation results show that oil recovery can be improved effectively with the addition of the third-phase slug. The addition of the third phase results in much more interfacial interaction between different phases, which helps recover trapped oil in pore corners, narrow throats, and the high permeability zone in the porous medium. Moreover, the injection volume, injection timing, contact angle, and viscosity of the third phase influence the oil recovery in different ways. The injected slug can also be trapped in the porous medium, which may result in formation damage. The study explains the enhanced oil recovery mechanisms of slug-assisted water flooding at the pore scale and provides an effective way to design the injection scheme during industrial production.