This work presents an experimental study of the performance and emissions of an internal combustion engine operating in the Otto cycle with a high volumetric compression ratio (17:1). The engine was initially fueled with the standard ethanol used in Brazil, with 7% distilled water (E93W07); we then studied the effects of using different ethanol-in-water mixtures, or ‘wet ethanol’, with 17%, 27%, 37%, and 47% distilled water concentrations. The tests were carried out with power loads of 5.0–25.0 kW at 5.0 kW intervals and with power loads of 27.5–35.0 kW at 2.5 kW intervals, whether by adding up the loads or by taking them away. The ignition timing was changed to evaluate each load imposed on the engine to avoid knocking. Specific fuel consumption (SFC), brake thermal efficiency (BTE), carbon dioxide emissions (CO2), carbon monoxide (CO), nitrogen oxides (NOx), and total hydrocarbon content (THC), as well as the internal pressure in the cylinder and the heat release rate, were measured, and the results are compared. The results show a reduction in CO and NOx and an increase in THC emissions. However, there were no significant changes in CO2 emissions when the distilled water percentage in ethanol increased. Regarding the brake thermal efficiency, it was observed that it remained approximately constant for all blends, with the same load being applied to the engine shaft, reaching a maximum value of 35%. The results obtained confirm the technical feasibility of operating an internal combustion engine in the Otto cycle with a high volumetric compression ratio using ethanol with up to 47% distilled water without significant loss of performance.
This research evaluates the performance and pollutant emissions of a motor generator set equipped with a compression ignition engine, adapted to operate with the direct injection of ethanol and diesel oil. Fuel injection was conducted with separate systems. The experiments were carried out with power loads varying from 15 kW to 37.5 kW, an ethanol injection angle of 40o crank angle degree (CAD) before the top dead center (BTDC), and a 23o CAD BTDC diesel injection angle. The diesel fuel was replaced with ethanol mass percentages ranging from 52% to 59%, with the ethanol being over-hydrated from 7% to 30% by the mass of water. The emissions and performance exhibited different behaviors, varying according to the power loads and hydration contents. The results showed significant reductions in the emissions of nitrogen oxides (NOx) and smoke opacity for all the fuel mixtures used. An increase of approximately 5% in engine fuel conversion efficiency was observed when operating with ethanol blends at higher power loads. The occurrence of an ignition delay with the use of wet ethanol did not vary significantly with the amount of water mass, but it did vary with the operating load. It was also found that a higher volume of water in the fuel promoted an increase in the in-cylinder pressure at higher loads. These results suggest that the use of a fuel mixture containing diesel oil and wet ethanol blends, directly injected by separate systems, can favor the reduction of emissions and reliance on petroleum-based fuels. This could potentially lead to a cost reduction in the production of this renewable fuel, without compromising the performance of the engine.