The paper focuses on the joint design of transmit steering vectors and receiver filters for integrated radar-communication waveforms in clutter. The primary objective is to maximize the output signal-to-clutter-plus-noise ratio (SCNR) to ensure optimal target detection performance and enhance communication transmission quality. To maximize transmitter efficiency, we utilize an alternating projection (AP) algorithm to restrict the peak-to-average power ratio (PAPR) of the transmitted waveform. To reduce the mutual interference of multiple transmitted signals in space, we propose the information data weight (IDW) to form interference direction nulls to ensure spatial orthogonality. To obtain multi-tranmit orthogonal constant modulus integrated waveforms, we propose a weighted autocorrelation integrated sidelobe (WAISL) method to improve signal isolation ratio, assuming knowledge of the clutter and target spectral distributions. Finally, the clutter is suppressed by establishing the maximum SCNR constraint function. The simulation results demonstrate that the designed integrated waveform not only fulfills the multi-functional requirements but also enhances the survivability of the radar waveform in clutter and the robustness of communication transmission.
Pulse compression technology can augment the likelihood of target discernment without degradation and without amplifying system hardware requisites. However, radar-communication integrated waveforms may cause mismatches in reception due to communication modulation, leading to increased loss in processing gain (LPG). This method aims to achieve communication transmission while suppressing near-range sidelobe interference (NRSI) with a minor sacrifice in LPG. An environment-based weighted mismatched filter (EWMF) design methodology is proposed to attenuate NRSI to the requisite level, with further control of LPG possible by adjusting communication modulation parameters. Moreover, the alternating direction method of multipliers is employed to jointly optimize the integrated waveform and filter design. The effectiveness of this method is demonstrated using the average sidelobe level over a specified region as the performance metric. Theoretical evaluation and experimental results confirm the applicability of waveforms using EWMF, effectively suppressing NRSI, and this method is suitable for all waveforms based on pulse compression processing. Notably, it offers cost-reduction advantages without requiring modifications to the radar transmitter or receiver.
In order to enable the artillery locating radar to grasp the battlefield dynamics in real time, a multi-sensor fusion method of the artillery locating radar was designed. Radar and infrared sensors are scientifically fused. Use the mode of radar shutdown and infrared sensor working normally to achieve continuous monitoring of battlefield dynamic. When the infrared sensor detects the target, it immediately triggers the radar to turn on, and reports the target's azimuth, pitch and other information to the radar host computer, thereby guiding the radar to quickly detect the target airspace. Experimental results show that this method can effectively shorten the early warning time, and it takes about 0.6s from infrared discovery to radar detection to the target. Radar and infrared sensor realize information complementation, and have better battlefield silence ability and survivability, which can provide strong support for our equipment to evade strikes and find enemy weapon launch positions.