Tongke Zhao

Dr. Tongke Zhao


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2016 in Atmospheric Environment
Verified
Journal Article
Closed access
TZTongke Zhao
Tongke Zhao
SSShi Shu
Shi Shu
QGQiuju Guo
Qiuju Guo
YZYifang Zhu
Yifang Zhu

25 May 2016 in PLOS ONE
Verified
Journal Article
Open access
PDF file
EJEoon Hye Ji
Eoon Hye Ji
Bingbing SunBingbing Sun
Bingbing Sun
TZTongke Zhao
Tongke Zhao
SSShi Shu
Shi Shu
CCChong Hyun Chang
Chong Hyun Chang
Shen HuShen Hu
Shen Hu
In this study, we have generated and characterized Electronic Cigarette (EC) aerosols using a combination of advanced technologies. In the gas phase, the particle number concentration (PNC) of EC aerosols was found to be positively correlated with puff duration whereas the PNC and size distribution may vary with different flavors and nicotine strength. In the liquid phase (water or cell culture media), the size of EC nanoparticles appeared to be significantly larger than those in the gas phase, which might be due to aggregation of nanoparticles in the liquid phase. By using in vitro high-throughput cytotoxicity assays, we have demonstrated that EC aerosols significantly decrease intracellular levels of glutathione in NHOKs in a dose-dependent fashion resulting in cytotoxicity. These findings suggest that EC aerosols cause cytotoxicity to oral epithelial cells in vitro, and the underlying molecular mechanisms may be or at least partially due to oxidative stress induced by toxic substances (e.g., nanoparticles and chemicals) present in EC aerosols.

1 August 2017 in Aerosol Science and Technology
Verified
Journal Article
Closed access
TZTongke Zhao
Tongke Zhao
CNCharlene Nguyen
Charlene Nguyen
CLChe-Hsuan Lin
Che-Hsuan Lin
HMHolly R. Middlekauff
Holly R. Middlekauff
KPKacey Peters
Kacey Peters
YZYifang Zhu
Yifang Zhu
The electronic cigarette (EC) is a new source of indoor airborne particles. To better understand the impacts of secondhand vaping (SHV) emissions on indoor air quality, real-time measurements of particle size distribution, particle number concentration (PNC), fine particulate matter (PM2.5), CO2, CO, and formaldehyde were conducted before, during, and after 10 min EC-use among 13 experienced users in an 80 m3 room. To assess particle transport in the room, multiple sampling locations were set up at 0.8, 1.5, 2.0, and 2.5 m away from the subjects. The arithmetic mean (standard deviation) of background PNC and PM2.5 concentrations in the room were 6.39 × 103 (1.58 × 102) particles/cm3 and 8 (1) μg/m3, respectively. At 0.8 m away from EC users, right after initiation of puffing, the PNC and PM2.5 concentrations can reach a peak of ∼105 particles/cm3 and ∼3 × 103 µg/m3, respectively, and then dropped quickly to background levels within 20 s due to dilution and evaporation. At the 0.8 m sampling location, the mean PNC and PM2.5 concentrations during puffing were 2.48 × 104 (2.14 × 104) particles/cm3 and 188 (433) µg/m3, respectively. In addition, two modes of SHV particles were observed at about 15 and 85 nm. Moreover, concentrations of SHV particles were negatively correlated with the distances to EC users. At the 1.5 m location, PNC and PM2.5 levels were 9.91 × 103 (1.76 × 103) particles/cm3 and 19 (14) µg/m3, respectively. Large variations of mean PNC levels exhaled per puff were observed both within and between EC users. Data presented in this study can be used for SHV particle exposure assessment. Copyright © 2017 American Association for Aerosol Research

YWYue Wang
Yue Wang
SLShan-Jiang Liu
Shan-Jiang Liu
WXWentao Xue
Wentao Xue
HGHe Guo
He Guo
XLXinrong Li
Xinrong Li
Hongmin DongHongmin Dong
Hongmin Dong
This study aimed to investigate the characteristics of gaseous emission (methane—CH4, carbon dioxide—CO2, nitrous oxide—N2O, nitric oxide—NO, hydrogen sulfide—H2S and sulfur dioxide—SO2) and the conservation of carbon (C), nitrogen (N), and sulfur (S) during cattle manure composting under different aeration strategies. Three aeration strategies were set as C60, C100, and I60, representing the different combinations of aeration method (continuous—C or intermittent—I) and aeration rate (60 or 100 L·min−1·m−3). Results showed that C, N, S mass was reduced by 48.8–53.1%, 29.8–35.9% and 19.6–21.9%, respectively, after the composing process. Among the three strategies, the intermittent aeration treatment I60 obtained the highest N2O emissions, resulting in the highest N loss and greenhouse gas (GHG) emissions when the GHG emissions from power consumption were not considered. Within two continuous aeration treatments, lower aeration rates in C60 caused lower CO2, N2O, NO, and SO2 emissions but higher CH4 emissions than those from C100. Meanwhile, C and N losses were also lowest in the C60 treatment. H2S emission was not detected because of the more alkaline pH of the compost material. Thus, C60 can be recommended for cattle manure composting because of its nutrient conservation and mitigation of major gas and GHG emissions.

15 September 2016 in PLOS ONE
Verified
Journal Article
Open access
PDF file
LCLimin Chuan
Limin Chuan
PHPing He
Ping He
TZTongke Zhao
Tongke Zhao
HZHuaiguo Zheng
Huaiguo Zheng
XXXinpeng Xu
Xinpeng Xu
In order to make clear the recent status and trend of wheat (Triticum aestivum L.) production in China, datasets from multiple field experiments and published literature were collected to study the agronomic characteristics related to grain yield, fertilizer application and nutrient use efficiency from the year 2000 to 2011. The results showed that the mean grain yield of wheat in 2000–2011 was 5950 kg/ha, while the N, P2O5 and K2O application rates were 172, 102 and 91 kg/ha on average, respectively. The decrease in N and P2O5 and increase in K2O balanced the nutrient supply and was the main reason for yield increase. The partial factor productivity (PFP, kg grain yield produced per unit of N, P2O5 or K2O applied) values of N (PFP-N), P (PFP-P) and K (PFP-K) were in the ranges of 29.5~39.6, 43.4~74.9 and 44.1~76.5 kg/kg, respectively. While PFP-N showed no significant changes from 2000 to 2010, both PFP-P and PFP-K showed an increased trend over this period. The mean agronomic efficiency (AE, kg grain yield increased per unit of N, P2O5 or K2O applied) values of N (AEN), P (AEP) and K (AEK) were 9.4, 10.2 and 6.5 kg/kg, respectively. The AE values demonstrated marked inter-annual fluctuations, with the amplitude of fluctuation for AEN greater than those for AEP and AEK. The mean fertilizer recovery efficiency (RE, the fraction of nutrient uptake in aboveground plant dry matter to the nutrient of fertilizer application) values of N, P and K in the aboveground biomass were 33.1%, 24.3% and 28.4%, respectively. It was also revealed that different wheat ecological regions differ greatly in wheat productivity, fertilizer application and nutrient use efficiency. In summary, it was suggested that best nutrient management practices, i.e. fertilizer recommendation applied based on soil testing or yield response, with strategies to match the nutrient input with realistic yield and demand, or provided with the 4R’s nutrient management (right time, right rate, right site and right fertilizer) should be adopted widely to improve the yield production and nutrient use efficiency.

29 December 2016 in PLOS ONE
Verified
Journal Article
Open access
PDF file
EJEoon Hye Ji
Eoon Hye Ji
BSBingbing Sun
Bingbing Sun
TZTongke Zhao
Tongke Zhao
SSShi Shu
Shi Shu
CCChong Hyun Chang
Chong Hyun Chang
SHShen Hu
Shen Hu
[This corrects the article DOI: 10.1371/journal.pone.0154447.].