Safe and sustainable energy storage systems with the ability to perform efficiently during large numbers of charge/discharge cycles with minimum degradation define the main objective of near future energy storage technologies. Closing the gap between high power and energy per unit weight requires new materials that can act as a battery and capacitor at the same time. Conductive polymers have attracted attention as hybrid battery-capacitor materials. However, their potential impact has not been fully investigated because their behaviour, especially in non-aqueous electrolytes such as ionic liquids, is not completely understood. Here, we aim to clarify the fundamental functionality of these hybrid characteristics while studying the interaction between a conductive polymer and an ionic liquid by in situ atomic force microscopy and electrochemical quartz crystal microbalance. The main achievement is the visualisation of the morphological modifications of the conductive polymer depending on the state of charge. These modifications significantly influence the viscoelastic material properties of the polymer. Our combined findings provide a model which explains why conductive polymers behave like (pseudo)-capacitors at a high state of charge and as batteries at a low state of charge. This understanding enables application-orientated synthesis of conductive polymers and their use as high-performance energy storage materials.
5 July 2024 in Journal of the American Chemical Society
Extreme scenarios of high discharge current must be understood for better battery management system design. Physics-based modeling can give a better insight into the battery response but can be challenging due to the large number of parameters. In this work, an electrochemical pseudo-2D model is developed and used in the parameter identification and validated under high current discharge conditions. Commercial 18 650 cells with maximum rated current of 20 A (13.3 C) are characterized with discharge rates up to 40 C under controlled thermal conditions. The proposed three-step parameter identification procedure starts with the open circuit voltage being used to estimate the equilibrium potentials. In a second step, kinetic parameters are identified under high current aided by a parameter sensitivity analysis and parameter optimization with an evolutionary algorithm. The third step is the verification by comparing simulation results with measurements resulting in root main square error under 89 mV for currents until 26.6 C. Limits of the model are explored in the 33.3 C case, where a parameter re-fit shows that polarization effects change for very high current.