The mathematical formulation for the optical setup of a typical EARLINET lidar system is given here. The equations describing a lidar system from the emitted laser beam to the projection of the telescope aperture on the final receiving unit (i.e., photomultiplier or photodiode) are presented, based on paraxial approximation and geometric optics approach. The receiving optical setup includes a telescope, a collimating lens, an interference filter and the ensemble objective eyepiece. The set of the derived equations interconnects major parameters of the optical components (e.g., focal lengths, diameters, angles of incidence), revealing their association with the distance of full overlap of the system. These equations may used complementarily with an optical design software, for the preliminary design of a system or can be used as a quick check up tool of an existing lidar system. The evaluation of the formulation on a real system is performed with ray-tracing simulations, revealing an overall good performance with relative differences of the order of 5 % mainly attributed to the limitations of the thin lens approximation.

Vertical profiling of aerosol particles was performed during the PANhellenic infrastructure for Atmospheric Composition and climatE chAnge (PANACEA) winter campaign (10 January 2020–7 February 2020) over the city of Ioannina, Greece (39.65° N, 20.85° E, 500 m a.s.l.). The middle-sized city of Ioannina suffers from wintertime air pollution episodes due to biomass burning (BB) domestic heating activities. The lidar technique was applied during the PANACEA winter campaign on Ioannina city, to fill the gap of knowledge of the spatio-temporal evolution of the vertical mixing of the particles occurring during these winter-time air pollution episodes. During this campaign the mobile single-wavelength (532 nm) depolarization Aerosol lIdAr System (AIAS) was used to measure the spatio-temporal evolution of the aerosols’ vertical profiles within the Planetary Boundary Layer (PBL) and the lower free troposphere (LFT; up to 4 km height a.s.l.). AIAS performed almost continuous lidar measurements from morning to late evening hours (typically from 07:00 to 19:00 UTC), under cloud-free conditions, to provide the vertical profiles of the aerosol backscatter coefficient (b_aer) and the particle linear depolarization ratio (PLDR), both at 532 nm. In this study we emphasized on the vertical profiling of very fresh (~hours) biomass burning (BB) particles originating from local domestic heating activities in the area. In total, 33 out of 34 aerosol layers in the lower free troposphere were characterized as fresh biomass burning ones of local origin, showing a mean particle linear depolarization value of 0.04 ± 0.02 with a range of 0.01 to 0.09 (532 nm) in a height region 1.21–2.23 km a.s.l. To corroborate our findings, we used in situ data, particulate matter (PM) concentrations (PM_2.5) from a particulate sensor located close to our station, and the total black carbon (BC) concentrations along with the respective contribution of the fossil fuel (BC_ff) and biomass/wood burning (BC_wb) from the Aethalometer. The PM_2.5 mass concentrations ranged from 5.6 to 175.7 μg/m³, while the wood burning emissions from residential heating were increasing during the evening hours, with decreasing temperatures. The BC_wb concentrations ranged from 0.5 to 17.5 μg/m³, with an extremely high mean contribution of BC_wb equal to 85.4%, which in some cases during night-time reached up to 100% during the studied period.

We report on a long-lasting (10 days) Saharan dust event affecting large sections of South-Eastern Europe by using a synergy of lidar, satellite, in-situ observations and model simulations over Athens, Greece. The dust measurements (11–20 May 2020), performed during the confinement period due to the COVID-19 pandemic, revealed interesting features of the aerosol dust properties in the absence of important air pollution sources over the European continent. During the event, moderate aerosol optical depth (AOD) values (0.3–0.4) were observed inside the dust layer by the ground-based lidar measurements (at 532 nm). Vertical profiles of the lidar ratio and the particle linear depolarization ratio (at 355 nm) showed mean layer values of the order of 47 ± 9 sr and 28 ± 5%, respectively, revealing the coarse non-spherical mode of the probed plume. The values reported here are very close to pure dust measurements performed during dedicated campaigns in the African continent. By utilizing Libradtran simulations for two scenarios (one for typical midlatitude atmospheric conditions and one having reduced atmospheric pollutants due to COVID-19 restrictions, both affected by a free tropospheric dust layer), we revealed negligible differences in terms of radiative effect, of the order of +2.6% (SW_BOA, cooling behavior) and +1.9% (LW_BOA, heating behavior). Moreover, the net heating rate (HR) at the bottom of the atmosphere (BOA) was equal to +0.156 K/d and equal to +2.543 K/d within 1–6 km due to the presence of the dust layer at that height. On the contrary, the reduction in atmospheric pollutants could lead to a negative HR (−0.036 K/d) at the bottom of the atmosphere (BOA) if dust aerosols were absent, while typical atmospheric conditions are estimated to have an almost zero net HR value (+0.006 K/d). The NMMB-BSC forecast model provided the dust mass concentration over Athens, while the air mass advection from the African to the European continent was simulated by the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model.

Mean optical and microphysical aerosol properties of long-range transported biomass burning (BB) particles and mixtures are presented from a 9-year (2011–2019) data set of multiwavelength Raman lidar data, obtained by the EOLE lidar over the city of Athens (37.58° N, 23.47° E), Greece. We studied 34 aerosol layers characterized as: (1) smoke; (2) smoke + continental polluted, and (3) smoke + mixed dust. We found, mainly, small-sized aerosols with mean backscatter-related (355 nm/532 nm, 532 nm/1064 nm) values and Ångström exponent (AE) values in the range 1.4–1.7. The lidar ratio (LR) value at 355 nm was found to be 57 ± 10 sr, 51 ± 5 sr, and 38 ± 9 sr for the aerosol categories (1), (2), and (3), respectively; while at 532 nm, we observed LR values of 73 ± 11 sr, 59 ± 10 sr, and 62 ± 12 for the same categories. Regarding the retrieved microphysical properties, the effective radius (reff) ranged from 0.24 ± 0.11 to 0.24 ± 0.14 μm for all aerosol categories, while the volume density (vd) ranged from 8.6 ± 3.2 to 20.7 ± 14.1 μm⁻³cm⁻³ with the higher values linked to aerosol categories (1) and (2); the real part of the refractive index (mR) ranged between 1.49 and 1.53, while for the imaginary part (mI), we found values within 0.0108 i and 0.0126 i. Finally, the single scattering albedo (SSA) of the propped particles varied from 0.915 to 0.936 at all three wavelengths (355–532–1064 nm). The novelty of this study is the provision of typical values of BB aerosol properties from the UV to the near IR, which can be used in forecasting the aerosol climatic effects in the European region.

We analyze ten years (2008–2017) of ground-based observations of the Aerosol Optical Depth (AOD) in the atmosphere of Kuwait City, in Middle East. The measurements were conducted with a CIMEL sun-sky photometer, at various wavelengths. The daily average AOD at 500 nm (AOD₅₀₀) is 0.45, while the mean Ångström coefficient (AE), calculated from the pair of wavelengths 440 and 870 nm, is 0.61. The observed high AOD₅₀₀ values (0.75–2.91), are due to regional sand and dust storm events, which are affecting Kuwait with a mean annual frequency of almost 20 days/year. The long-term record analysis of AOD₅₀₀ and AE, shows a downward and upward tendency respectively, something which could be attributed to the continuous expansion and industrialization of the main city of Kuwait, in combination with the simultaneous increase of soil moisture over the area. By utilizing back trajectories of air masses for up to 4 days, we assessed the influence of various regions to the aerosol load over Kuwait. The high aerosol loads during spring, are attributed to the dominance of coarse particles from Saudi Arabia (AOD₅₀₀ 0.56–0.74), a source area that contributes the 56% to the mean annual AOD₅₀₀. Other dust sources affecting significantly Kuwait originated from the regions of Iraq and Iran with contribution of 21%.